Remove the cover of water heater terminal box (Fig. 1, Item m) IS ELECTRICITY TURNED OFF? NOTE COLORS OF WIRES. Disconnect wires and cable connector. cover to make sure the holes in cover line up. Adjust, if required. STEP 9 Set your daily program.
Warranty, Microtherm, Inc. will pay up to $65.00 for labor to install or replace any part or component found to be defective in material or 1-1/2” GREATER THAN THE LOWER EXTERNAL DIMENSIONS OF THE WATER HEATER, INCLUDE A SPLASH COVER
Recently released inspection reports of Lucas County food-service operations.
BEFORE REMOVING THE COVER OR SERVICING THE WATER HEATER, MAKE SURE THE ELECTRICAL SUPPLY TO THE WATER HEATER IS TURNED “OFF”. FAILURE TO DO THIS COULD RESULT IN DEATH, SERIOUS BODILY INJURY, open up the outlet ball valve slightly to achieve a higher rate of flow.
Storage Water Heater TOOLS REQUIRED: Pair of scissors or utility knife Materials List (1) pc. 48” X 84” piece radiant barrier insulation Do not cover up the gas controls, burner assembly, or consumer warning labels. Allow at least twelve (12) inches
After the solar water heater completes a heat–up cycle, check the water temperature at a faucet. Allow enough water Cold Water Inlet Diptube 16. Access Cover 6. Electrical Outlet Cover 17. Exchanger Escutcheon 7. Conduit Grounding Cover 18.
3 Equipment Manufacturers to Watch
Commercial Gas Water Heaters UP TO 96% THERMAL EFFICIENCY, DIRECT VENT *Minimum clearance to remove top cover WATER LEFT HEATER WALL LEFT WALL RIGHT WALL RIGHT WALL *1” (2.5 cm) TOP COVER 0$;,080 (48,9$/(17 9(17 /(1*7+6 %7+ 1XPEHU RI
Solar water heater will cover up to 80% of your annual hot water needs. You will save up to 80% (100% in the summer) on energy bills whilst allo- wing an equivalent reduction in your CO² emissions. In sunny climates (for example, the French
This instruction has been prepared to acquaint you with the service of your gas- ﬁ red water heater. Lift up and remove casing top (front). Remove the ten screws that secure the front cover of the heat engine. Remove the front cover of the Heat
A hot water circulation loop, where the water heater is in series with a circulation system and all (such as but not limited to scale build‐up, freeze damage, or vent This Limited Warranty does not cover any product used in an application that uses
cover from the water heater. 2. Carefully remove the existing program chip, see Figure 1 for location. 10. Press the UP arrow temperature adjustment button several times to increase the temperature to a maximum of 185*, see Figure 4.
If water floods house, the clean-up in responsibility of homeowner. This is why product manuals recommend installing water heater in drip pan. Again, the warranty does not cover water heater that does not work due to installation environment, or improper
COVER UP Pools lose heat through convection, evaporation and radiation from the pool surface, and by conduction pool heater Flow control valve Sensor SOLAR WATER HEATER SYSTEM Solar collectors become part of the existing system.
Remove the water heater front cover by loosening the 4 Phillips head screws securing it to the case. 5. allows for up to 2 GPH of drainage for each water heater in the system. If you are not using a condensate pump, ensure that the drain
Pick up more protection Please read about PSE&G’s Extended Labor Warranty for your water heater. It protects you from designated contractor and PSE&G will cover the full cost of the water heater replacement, excluding permit fees, subject