temperature setting of a water heater’s gas control. Water temperatures above 125°F (52°C) can cause severe burns or death from scalding. To adjust the temperature, turn the temperature dial to an initial setting of 120°F (49°C).
WATER LEAKAGE: Condensation Adjust the thermostat setting (p 24). Dripping Temperature & Pressure Relief Valve Due to the nature of the typical gas water heater, the water temperature in certain situations may vary up to 30°F (16.7 °C) higher or lower at the point of use such as,
That way if you need to adjust the temperature a bit higher, you can easily see where you started. consider turning your gas water heater thermostat to the pilot READ ON! WHEN I HEARD WATER HEATING ACCOUNTED FOR 20% OF MY ENERGY BILL, I STARTED LOOKING FOR WAYS
TANKLESS GAS WATER HEATER Owner’s Guide Feel water temperature before bathing or showering. Temperature limiting valves are available, ask professional person. adjust the settings on the water heater for use with the proper gas type.
The Rinnai water heater may adjust the button for 5 seconds while the water heater is OFF. Temperature Options Without a Temperature Controller Turn off the power source and gas supply to the water heater / Coupez l`alimentation de gaz et électrique.
On-Demand Gas Tankless Water Heater Service Manual Water Temperature Regulation For systems with storage tanks, the water 10. Adjust dip switches on the new PC board. 11. Attach connections and plastic cover. 12.
Temperature Gas Shutoff Valves Installation Instructions NOTE: See C.S.A. directory for adjust-ment factors when used with manufac-tured, mixed and L.P. gas-air mixtures. Three acceptable positions for installing are shown in sketches below. water heater manufacturer’s warranty.
Control and how to adjust the water temperature. Notice: The factory setting allows operating temperatures between 100°F (38°C) and 120°F (49°C). Temperatures For the PALOMA Gas Water Heater Models listed on the front of this manual.
The Rinnai water heater may adjust the button for 5 seconds while the water heater is OFF. Temperature Options Without a Temperature Controller Rinnai water heater is not of the gas type that the building is supplied with,
Instructions for lowering the temperature: Gas water heaters: Find the dial near the burner and reduce the temperature setting. 5 ELECTRIC STORAGE WATER HEATER HEAT Turn off the electricity to the water heater before adjust-ing the temperature. Remove the two thermostat covers. Use a screwdriver
Install gas water heater at least 18” off floor since gasoline vapors stay low to the ground. The temperature of the water in the heater can be regulated by setting the adjust the gas flow. An incorrect burner flame can result.
RESIDENTAL GAS WATER HEATER SERVICE This portion of this manual applies to the Operations and Servicing of Residential Gas, Tank Type, water temperature may drop 15 – 25° F, around the temperature probe, before the main burner is activated.
(La Mesa Courier, La Mesa, CA) –
The temperature and that the water heater is ready to supply hot water. pipe to the water heater. NOTICE WARNING DO NOT adjust the other dip about the size of the gas line. The water heater requires a standard 3 prong 120 VAC,
Adjust ignitor tip. Thermocouple malfunction. Refer to TEMPERATURE REGULATION. WATER HEATER SOUNDS Condensation dripping on burner. Estimated cost for operating Gas water heater (2010) Size 40-50 gallon Energy factor Natural Gas LP Gas