Will reset when pilot flame is sufficient. 1. Gas Control is functioning normally. 2. Gas Control is not powered. Light Remove Gas Control from water heater by rotating counter clockwise. DO NOT use a wrench Upon completion of the cast iron burner adjustment procedure, the inner door
COMMERCIAL GAS WATER HEATER Improper installation, adjustment, alter-ation, service, or maintenance can cause Check for a soft blue flame. • Leaking or damaged water and gas piping. • Presence of flammable or corrosive materials in the
gas water heater or other open flame or spark produc-ing appliance. Also, 13 Gas Control Valve 14 Temperature Adjustment Knob* 15 Dip Tube 16 Flue Baffle 17 Draft Hood # Manual 13 14 15 16 17 1 2 3 4 5 7 6 8 9 11 10 12 22. Notes 23. Title: 184115-000 Author: David
TECHNICAL SPECIFICATION FOR GAS HEATER (SEONG SAN, HOTAN it is also a requirement for back gouging, electric arc cutting, and flame cutting. If required, post weld (full of water) kg V-14 Heater insulation Thickness mm 65 Material mineral wool Jacket Aluminium 1.2mm
And adjustment of the water heater; and two, to the owner–operator, to explain the features, operation, safety precautions, maintenance and an open flame to test for gas leaks, as property damage, personal injury, or death could result.
adjustment of the water heater; and two, to the owner–operator, to explain the features, operation, safety precautions, an open flame to test for gas leaks, as property or death could result. Pressure Testing the Gas Supply System
ACCESS PANELS – WATER TEMPERATURE ADJUSTMENT IS BEHIND THESE PANELS. RECOMMENDED SETTING IS contact with a flame (a gas water heater uses 12 cubic feet of air for each 1000 BTU of heat generated). When these chemical vapors or dusts come
AIR SHUTTER ADJUSTMENT FOR FLAME GUARD (L.P. – 30T ONLY) L.P. Gas Model 30T Important: For correct water heater operation, it is essential that the air shutter be properly adjusted.
adjustment of the water heater; and two, to the owner–operator, to explain the features, operation, safety precautions, maintenance and an open flame to test for gas leaks, as property damage, personal injury, or death could result.
Vent-Free Gas Wall Heater Blue Flame WARNING:This appliance is equipped for (Natural and Propane) gas. Field conversion is not permitted Inlet Gas Pressure* (inches of water) * For purposes of input adjustment. Maximum 10.5 in. 10.5 in. 10.5 in.
Is thermostat calling for heat? Run (hot) water from heater and set adjustment button higher. Check using a manometer at thermostat pressure tap. Is there a minimum gas pressure 4" (1kPa) W.C. Flame signal sensed out of 1. Replace gas control valve. proper sequence. ECO activated. 1.
Temperature Adjustment Heater Shutdown Water Heater Operation Lighting Instructions The gas-fired water heater igniter or burn-er flame can ignite these vapours causing a flashback, fire • Do not connect a L.P. gas water heater to a natural gas supply
adjustment section in this operator’s manual for there is an open flame, spark or pilot light such as a water heater, furnace, clothes dryer etc. spark or pilot light as on a furnace, water heater, clothes dryer or gas appliance. 20 SECTION 8: