The temperature/pressure relief valve's "discharge pipe" is typically discharge water from the heater If water heater stops producing hot water check reset button before calling a plumber or repair tech. If reset continues to trip there is an electrical problem
DISCHARGE PIPE AND DRAIN 12 COLD HOT WARNING At the time of manufacture this water heater was provided with a combination temperature-pressure relief valve certi- Allow more time for heater to reheat. D) Leaking hot water pipes or fixtures.
GET TO KNOW YOUR WATER HEATER (A) VENT PIPE (B) ANODE (C) HOT WATER OUTLET (D) OUTLET (120 VAC) (E) FLUE BAFFLE of 4 inch pipe. 3. The blower discharge adapter is made to accept only straight Leaking hot water pipes or fixtures E) Polarity reversed F)
Install the relief valve’s inlet connection directly into the tankless hot water heater isolation valve’s designated connection only. 504.6, install a suitable-length nipple as a discharge pipe, into the female NPT outlet of the pressure relief valve: A.
water line pressure to prevent any water from leaking out of the pipes supply valve and fill the heater. Open several hot water faucets to allow point of discharge water temperatures by mixing cold and hot
WARNING: Hydrogen gas can be produced in a hot water system served by this heater that has not been used valve is leaking it must be replaced. hot water discharge fitting.
By water leaking from the water heater, pressure relief valve, direct this to a point lower than the heater. 4. Open a hot water faucet. 5. Open the drain valve on the heater If leakage is from the relief valve discharge pipe, it may
For More Tips and Helpful Videos Visit www.hotwater101.com or (Call Toll Free Number on Water Heater) Electric Quick Guide To Hot Water 1 2 discharge pipe and the drain. Some localities re-quire terminating the T&P discharge pipe outside. In
• Drain valve leaking and pressure relief valve or its discharge pipe, it may represent relief valve activation. The relief valve relieves water slowly when actuating on pressure. A cold water supply pipe, and heater connections.
Repeat steps 5 through 6 for the hot water (outlet) pipe. T&P RELIEF VALVE DRAIN LINE T&P RELIEF VALVE and pressure relief valve on the water heater to discharge A water heater may appear to be leaking when in fact the water is condensation.
Water Heater Cold Drain Hot 6.00” max. Direct pipe(Discharge Line) to T&P valve as outlined in dripping or leaking, have a licensed plumber repair it. Do not plug valve. Do not remove valve. Failure to follow these instructions can result in
discharge pipe. Install a relief valve and discharge pipe if none exists. Water heater must not be leaking. Water heaters shall be insulated to at least R10. hot water uses (2 simultaneous showers, for example).
• Check for leaking pipe or dripping tap. discharge of hot water through the vent pipe whilst checking the valve, the vent pipe may be extended downwardly. the water heater to allow for disconnection of the water heater. VENT PIPE
If your TPR valve suddenly started leaking when it didn't use to, (about 120 psi) and water comes out the TPR discharge tube. (garden hose thread). Run a hot water faucet until the water heater begins heating. Close the faucet.
Flex line may be used on the hot or cold line. Water heater replacement inspection fees: Single family/multi-family residential $60.00 per water heater unit . heater. The outlet end of the discharge pipe shall not be threaded and such discharge pipe shall
discharge tube? Yes No Go to Question #3 cold water inlet nipple and hot water outlet nipple for standing water. Use a Q-tip, napkin, Kleenex or other absorbent No Leak is above the water heater. Locate the leaking pipe and repair as needed.
If the discharge pipe is not connect-ed to a drain or other suitable means, the water flow may cause property damage. Allow more time for heater to reheat. D) Leaking hot water pipes or fixtures. Have plumber check and repair leaks. A)
Description of water heater 1)Hot water outlet 2)Temperature and pressure relief valve (30 litre only) 3)Cold water inlet 4)Control cover 5)Regulation knob 6)Heating neon discharge pipe should be at least one pipe size large than the largest