The maximum temperature of the hot water from the heater is 50℃. 3. When the unit is turned off and turned on again some care should be taken Screen display E2 Screen display E3 Power supply is short circuiting or electric current leakage
Energy Smart® Electric Water Heater The Energy Smart® electric water heater integrates a consumer friendly, heads up display and user interface, with a high effi ciency on the LCD screen. No single point of failure means hot water is always available. Unlike
water pump with debris screen. Tips for Best Performance: Hot Tap heater until proper water pressure is regained. Check that all hoses are free of kinks. Most kinks occur during storage or immediately after use when the hoses are warm.
Supplies. The investigating crew removed strainer screens in the dishwasher, the aerator screen on the kitchen sink, and the showerhead in both apartments. the hot water heater was in fact the cause of the problem and not our incoming water.
screen for vent length greater than 6.1 equivalent metres (20 equivalent ft.) (see Figure 7). NOTE: VENT PIPE MUST BE SUPPORTED EVERY 1.2m (4 ft.). TO PREVENT VIBRATION, USE ISOLATION used at the hot–water faucets or at the water heater. Mixing
screen for vent length greater than 20 equivalent ft. (6.1 equivalent metres) (see Figures 32 & 33). hot water from this heater ﬁ ts into one of these groups or if there is a local code or state law requiring certain
Valve on the hot water heater discharges periodically, this may be due to thermal expansion in a closed water system. Contact the water supplier or your plumbing contractor on how to correct this. and the screen says water heater system.
Located in cold water inlet of water heater. Clean the screen of any sediment or dirt and reinstall the filter. Heater Hot Water Isolation Valve Cold Water Isolation Valve Technical Competence, Product Confidence RTG11001.pdf ST (07/06) Page 1 of 1
screen should be cleaned of any buildup of debris or foreign material. flame sensor The control system monitors the flame sensor to confirm that flame is present at the burner. If anyone using hot water provided by the water heater being
14. AFTER TIGHTENING BOTH FITTINGS AT THE WATER HEATER OPEN SEVERAL HOT WATER FAUCETS AND ALLOW WATER TO RUN THROUGH THE WATER HEATER FOR AT LEAST 3 MINUTES. THIS If the screen is touched, it will be lighted again. 5.
Instant Hot Water Heater. 1 Thankyou for choosing the GL5-15 complete home instant hot water unit. Clear LCD screen displays the actual outlet water temperature New die-cast heating tank, 1.Protects against dry heating and overheating;
Clean and reinstall air intake screen. STAY LIT Flame arrestor openings blocked. Contact a service agency to determine cause. Defective Gas Control. Heater undersized. Reduce hot water use. NOT ENOUGH Low gas pressure. Contact your gas supplier.
Cleaning the screen and under the heater can improve the performance of the heater and save a costly service call. in the hot water outlet of the heater, will allow much hotter tank temperatures while providing a worry free solution to scalding.