Label on the heater, proceed to light the pilot and allow to operate for three minuets. If the pilot will not stay lit, water heater’s rated manifold pressure (check rating plate). Line pressure must be checked with the main burner on and
Products from the pilot stall in the heater flue pipe, and the pilot runs out of oxygen because there is no draft If no light can be seen from the soffit areas, With proper installation your State water heater will
Light Duty Commercial Power Direct Vent Energy Saver Gas Water Heater The LD Power Direct Vent FVIR Defender Safety System® Models Feature: Bradford White ICON System™—Intelligent gas control with spark to pilot ignition system
Pilot Light Troubleshooting Flowchart supply to the water heater’s burner and pilot, preventing re-ignition of any remaining flammable vapors in the area. This will not prevent a possible fire/explosion if the igniter
water heater pilot light or main burner can ignite such vapors. The resulting flashback and fire can cause death or serious burns to anyone in the area, as well as prop-erty damage. If installation in such areas is your only option, then the
The gas-fired water heater pilot or main burner flame can ignite these vapors causing a flashback, fire or explosion which may result in serious personal To light heater, remove outer door and slide inner door to the right. 5. Find pilot.
There is no need for matches to light the water heater. PILOT IGNITER A permanent pilot flame burns to ignite the main burner automatically. Heat from the pilot is absorbed by the water. ABOUT YOUR WATER HEATER 6 WARNING This
Out the pilot light. Look for a fan (like a ceiling fan) in the same room that could potentially cause a down draft. the water heater may not have enough air (in volume) to operate. A ‘confined space’ is defined as having less than 50
Electronic Ignition – No Pilot Light 3” Combustion Air Intake (with optional kit) OPTIONAL ACCESSORIES Direct Vent Conversion Kits (indoor) Water heater(s) shall be Model _____ as manufactured by A. O. Smith. The
pilot will light. Ventilate water heater location. Raise height of outdoor vent termination. Power vent models: install condensate tee. Correct venting problem PILOT WILL NOT LIGHT OR REMAIN LIT Power vent 1. Low gas pressure 2. Air in gas line 3.
pilot light typically consumed 5 to 7 % of the natural gas used by a heater. Increased insulation is another feature that has reduced gas consumption by when purchasing a new gas water heater purchase the one with the lower operating costs.
Replacement of the entire water heater. RED LIGHT ON (SOLID) Pilot light was recently extinguished and the Thermopile is cooling down. Turn Gas Control Valve/Thermostat knob to OFF. Wait 10 minutes for the Thermopile to cool, then attempt
Supply to the water heater’s burner and pilot, preventing Section B: Pilot light will not remain lit or repeatedly goes out. Check for insufficient combustion air. Are there openings for make-up air to enter the room? Are the openings of sufficient size?
Light pilot 2. Turn temp. dial to desired temperature 3. Check with gas utility company 4. Replace igniter pilot assembly 11. Replace water heater, eliminate flammable vapors source. Call 1-800-999-9515 12. Check with gas utility company 13.
Lighting a Water Heater Pilot Light Instructions for lighting a pilot light should be on a plate mounted to the water heater. The instructions, which apply to most gas water heaters, are repeated here: 1. Turn the thermostat indicator knob to OFF.
Air to clear the lines before the pilot will light. • If knob does not pop up when released, stop and How to light Gas Water Heater http://waterheatertimer.org/How-to-troubleshoot-gas-water–heater.html . Title: 184165-003.pdf Author: Gene Haynes
Lighting a Water Heater Pilot Light Instructions for lighting a pilot light should be on a plate mounted to the water heater. The instructions, which apply to most gas water heaters, are repeated here: 1. Turn the thermostat indicator knob to OFF. a.
Lighting the Gas Valve This water heater has a new, advanced gas valve and lighting the pilot is different than on older models. To light the pilot, follow the lighting instructions on the water heater’s
Witnesses and people who live on Daly Street describe an explosion and building collapse that rocked their South Philly neighborhood, setting off a mad scramble to save lives.
See Unable to light pilot and Pilot does not stay lit See Main burner will not stay lit Not Enough Hot Water 1. Thermostat set too low 2. Water heater is leaking (Gas water heaters produce condensation 1. Cold in or hot out joints 2. T&P valve
The recently renovated South Philadelphia rowhouse that blew up this week in a natural gas explosion was thoroughly inspected and approved by city building inspectors just last week, Mayor Nutter said Tuesday, adding that he would wait for a report from city fire marshals before speculating on what caused the blast.