Water Heating, Combination Heating Storage Tanks, Gas Fired Unit Heater, Duct Furnaces and MUAs www.sterlinghvac.com System Sensor Duct Smoke Detectors and Accessories www.systemsensor.com Indirect Fired MAU Air Rotation Units
Finish materials shall comply with Section 1209 of the International Building Code. Attics containing a water heater shall be provided . . . or an indirect waste receptor. The discharge pipe shall not have any trapped sections.
water heater or storage tank, to a waste an approved indirect waste receptor or to the outdoors the International Building Code are permitted to be included in the number of required fixtures for either
Trane ..IBC Varidigm Corporation .. 7 1 AHRI trends | www.AHRInet.org. Sﬁ rst we had one of the coldest winters in a long qualifying indirect water heater (in conjunction with qualifying boiler) – 30 gal-lons (at least) R-16 insulation
Any drain or indirect waste pipe, and that protects against damage from accidental spills, fixture overflows and leakage. exceeding the tank or water heater manufacturer’s rated working pressure or 150 psi (1035 kPa), whichever is less.
IBC Technologies 1445 Charles Street, Vancouver, BC V5L 2S7 Canada www.ibcboiler.com Email: firstname.lastname@example.org Phone 604-877-0277 Fax 604 -877 0295 A good example is an indirect water heater. Without the type of protection described above,
(VCC/IBC 712.3 and VPC/IPC 307.3) BPRP9H WHEAT Provide a water heater detail of the following but not limited to: supply shut off valve, drain INDIRECT WASTE BPRP9S STORM Sections of the horizontal storm piping system(s) are undersized.
Passageway to the water heater shall not be less than 30 inches (762 mm) high and 22 inches (559 mm) wide. outside the building, an indirect waste receptor, or other approved location. The discharge shall terminate in a manner that does not
Water heater fee (16B.665) International Building Code Appendix J (Grading) See chapter 1300. Chapter 1306 Special Fire Protection Systems, either 1306.0020, subpart 2 (existing and new buildings) or subpart 3 (new buildings only)
IBC. One requires two! (Illustration on next slide) water heater and the auxiliary storage tank. • 802.2 Indirect waste piping increased from 24” to 30” for horizontal length; and from 48” to 54” for total developed length.
Ing fixtures affects the design of a building, Chapter 29 of the International Building Code (IBC) includes, verbatim, the size of a water heater, An indirect connection
Requirements for water heater discharge piping Reworded item #5 to read as follows: 5. an approved indirect waste receptor or to the outdoors the International Building Code are permitted to be