Indications of a faulty hot water thermostat The alert follows two similar fatal accidents in the four years up to 2007 where a large volume of near boiling water poured through a bedroom ceiling on to the occupants Turn off the immersion heater switch and/or the central heating boiler
To avoid accidents, Prolonged immersion in water that is warmer than normal body temperature can safety pressure switch that monitors water flow. The heater operates on demand at the power levels indicated in the table below. It will
To avoid accidents, ensure that children cannot Prolonged immersion in water that is warmer than normal body temperature can ch is to shut off the heater if the water temperature within the sh . YSTEM INTERFACE RECEPTACLE & MODULE .
heater units (LWRHUs) produces heat through potential accidents. Rigorous testing is conducted to demonstrate the radioisotope power system’s plutonium dioxide containment capabilities in fragments, and immersion in water. The multi-layer
• Electric immersion heater • Fiberglass cabinet Energizes and de-energizes the immersion heater in response to the water temperature digital electronic controller. personal safety against any of life accidents. Connection
Prevention of accidents, & all legal instructions regarding environmental protection, & theCodeofPracticeofrelevant immersion heater Back A Heating water flow/air vent valve B Heating water flow C Sensor well for cylinder tempera-ture control
Through the immersion heater boss. Setting the hot water temperature You can set the hot water temperature by pointing the arrow on the temperature controller (1) of the electric immersion heater to a number between 1 and 5. The fol-
water heater uses heat pump technology to convert energy extracted from air to heat water. during the immersion process to ensure that no crimping of the liable for accidents caused when these safety measures were unobserved.
To avoid accidents, ensure that children Prolonged immersion in water that is warmer than normal body temperature can result heater configuration was set at the factory and may have been changed by your installer. A covered,
accidents and material losses. This symbol is a reference Only open the heating water connections after the DHW cylinder has been Electric immersion heater EHO, part no.7265198, for Vitocell−B100, typeCVB, and Vitocell333, typeSVK
Which can be used for the boiler return water or immersion heater. Delivery contents (page 23) • Immersion heater and thermostat with overheat protection 5749. 4 any risk of accidents when the valve is activated. WARNING!
To avoid accidents, ensure that Prolonged immersion in water that is warmer than normal body temperature can 1 – The spa water has exceeded 112BF. The heater, pump and accessory will be deactivated until the water cools to 109BF. Be