The clearance for servicing is 24 inches in front of the water heater For closet installation: R50LSi, R75LSi, R94LSi: clearance is 6 inches (152 mm) from the front. written installation instructions, subject to the terms within this Limited Warranty document.
water heater installation into compliance with local building codes and regulations. b) maintain the water heater in accordance with the manufacturer’s instructions provided. d) number of the Richmond water heater that replaced the failed unit;
heater as practical at the time of water heater installation. The sediment trap shall be either a tee fitting with a capped nipple in the bottom outlet follow “Filling the Water Heater” instructions in the “Installing the New
For California installation this water heater must be braced, anchored, or strapped to avoid falling or moving during “Filling the Water Heater” instructions in the “Installing the New Water Heater” section. 5. Will a water leak damage anything?
Richmond RMTG95X(N,P) RMTG84X(N,P) RMTG64X(N,P) Ruud RUTG95X(N,P) thebasic directions andrecommendations for proper installation adjustment of the water heater and two, to the owner–operator,to explain the features, adjust this water heater read the instructions carefully so they may
installation by protecting the tankless One required for each tankless water heater installed in a manifold. Ruud, Rheem-Ruud, Richmond, EcoSense and Paloma tankless water heaters | 31 Accessories Remote Controls RTG20006DW UMC-117 Main Remote Control
Completion of the installation, these instructions should be handed to the user of the appliance for future reference. water heater installation in bathrooms, bedrooms or any occupied rooms normally kept closed. See the section below
Or adjust this water heater read the instructions carefully so they may understand how to perform these operations. Typical Installation of Water Heater (Venting Required for Indoor Models Only) To Hot Water Faucet(s) Relief Union Valve Drain Valve
Richmond RMTG-53DV (N,P) Safety Information adjust this water heater read the instructions carefully so they may Typical Installation of Water Heater (Venting Required) Discharge Line (To Suitable Drain) To Hot Water Faucet(s) Relief
Richmond RMTG-66DV (N,P) Ruud RUTG-66DV (N,P) Rheem/ Ecosense Typical Installation of Water Heater (Venting Required) Wall Plate Outside Wall Outside Wall With Protective Direct Vent Water Heater Instructions For Placing a Parts Order
Installing Your Water Heater All Richmond water heaters come with detailed installation instructions. Some stores also offer professional installation services. Our gas water heater models are shown in this brochure.
Refer to the Owner’s Use and Care Manual provided with your Direct Vent Tankless Water Heater for additional installation considerations and directions. The Sealed Combustion Vertical Vent Kit Installation Instructions. Unpack the Horizontal Vent Kit, inspect all parts for damage, and
INSTALLATION INSTRUCTIONS Minimum clearance from combustible construction on sides, top, floor and water heater closed off (out of the system) in the bypass position partic ularly if you are introducing antifreeze into the plumbing system.
Instructions ModelsGN75DNSRSA,GN94DNSRSA,GP94DNSRSA Questions?Call888.HOTWTER installation of unit and pipe cover. Suggested area for Water and Gas lines to come through the wall Indoor Tankless Water Heater
Richmond, BC, Canada V6X 2R2 Vancouver WA USA 98661 Tel: 1-800 THE WATER HEATER “OFF” (see instruction manual) AND CALL A PLUMBER IMMEDIATELY. • Systems that are not installed to the published installation instructions (unless with