Commercial Gas Water Heater MAGNESIUM ANODE RODS – to extend tank life. FULL SIZE HAND-HOLE CLEANOUT – for eased tank inspection and/or removal of sediment deposits. FACTORY INSTALLED ENERGY CUT-OFF SYSTEM AND PRESSURE/TEMPERATURE VALVE.
Removal of the magnesium anode and replacement with an aluminum anode may minimize the problem. Complete removal of the anode (magnesium or aluminum) will The following steps outline the proper procedure for chlorinating a water heater: 1)
Your water heater includes an anode rod that protects it from corrosion from the potable water. It should be checked every three to five years. If the removal. e) Place a bucket under the PRV, put the funnel in the fill hole and slowly
SOLAR ELECTRIC WATER HEATER & SOLAR STORAGE UNIT A Spanish language version of these instructions is available by contacting The removal of this anode, for any reason, will nullify the warranty. In areas where water is unusually active,
LIMITED RESIDENTIAL WATER HEATER WARRANTY furnished with the unit, removal of magnesium anode, disconnection, alteration or addition of non-approved components or apparatus, operation with fuels or at settings other than those set forth on
water heater tank. The anode is usually made of magnesium metal, which can supply electrons that aid in the conversion of sulfate to hydrogen sulfide gas. Removal of the anode, however, may significantly decrease the life of the water heater.
Removal of the installed (or failure to replace) listed 3/4" temperature-pressure relief valve will release the manufacturer from any claim which Your water heater has been equipped with an anode that protects the tank from corrosion. As the anode works, it
D. ANODE ROD This water heater is equipped with a magnesium anode rod. Anode rods are sacrificial components that counteract water chemistry to minimize or eliminate tank corrosion. 7 The anode rod should be inspected annually and replaced as necessary to prolong tank life.
Rod, or Power Anode. Pressurize water heater and let stand 20-30 minutes. Purge all of the hot taps individually until warm water comes out of the tap. a full water heater service – removal of scale with muck-vac, replacement of the anode rod and installa-
And replace anode rod as necessary. REMOVING WATER HEATER 1. Shut off gas supply and disconnect gas supply line from water heater. 2. On all Electric Models, disconnect 120 V.A.C. supply at junction box mounted on heater. 3.
Anode Inspection and Replacement Water heater maintenance includes periodic tank flushing and cleaning, and removal of lime scale. • Follow FILLING instructions when restoring hot water service. SEDIMENT REMOVAL
anode (supplied in the heater) may become over-reactive. To alleviate this, dismantling or removal of cupboards, doors, walls or special equipment and/ Please Register Your Water Heater Please take a moment to fill out your details for warranty
THROUGH -THE-WALL GAS WATER HEATER A Spanish language version of these instructions is available by contacting The removal of this anode, for any reason, will nullify the warranty. In areas where water is unusually active, an odor
Inner Door/Gasket Removal, Inspection Replacement and Reinstallation Inner Door Removal Procedure Step 1. remove outlet nipple/anode from the water heater. Use caution not to damage pipe threads. Step 5. Visually Inspect outlet nipple/anode.