A water heater permit may be issued only to State of California Licensed Contractors, Transition Collar/Firestop. Attic. Ceiling. Expansion Tank. if required. May be Listed Flex Vent, Single Wall or B Vent. Cold Water Shutof. f. Hot Water optional.
water heater from toppling during an earthquake, it must be secured to the wall in an approved manner. collar shall be placed against the ceiling to seal the gap between the sheetrock and the vent. 11. Pipe Insulation: The first 5’ of both cold
ceiling before it is noticed elsewhere. Condensate will form in the coldest part of the vent (near the termination) when the flue gas cools to its dew point water heater collar to eliminate this problem. Do not assume that because
In order to prevent the water heater from toppling during an earthquake, it must be secured to the wall in an approved manner. A metal collar shall be placed against the ceiling to seal the gap between the sheetrock and the vent.
WATER HEATER WITH DRAFT HOOD Fig 3 B-VENT WYE. 5 Firestop Supports are currently manufactured for pipe sizes of 3" through 12" should protrude a minimum of one inch below the ceiling. An optional Pipe Collar is available for decorative purposes. 6. Connectors.
Do not use water or detergents when cleaning the room then proceed to place the ceiling canopy over the collar at the top of the motor (Figure 11). 6. Reiker Room Conditioner Ceiling Fan Heater User Manual Author: R.E. Williams Contractor Inc.
Water Heater Replacement INFORMATION GUIDELINE ceiling of the appliance enclosure. That portion of a venting system which connects an appliance vent collar to its vent. Vent connectors used for gas water heaters with draft hoods may
ceiling or the wall. Refer to Step 3 or 4, as appropriate. TOTaL VEnT HEIGHT cOLLaR NorthlineExpress.com www.NorthlineExpress.com Toll-Free 1-866-667-8454 . 6 WaTER HEaTER WITH DRaFT HOOD B-VEnT WyE Figure 3 Figure 4 EXISTInG JOISTS EXISTInG SHEET ROcK
• Is the gas water heater flue/stack listed and approved for use with the appliance? Is there an approved fire stop collar at the ceiling line? • Does the water heater have a pressure-temperature relief valve and drain line?
Vent collar to termination. Termination must system that penetrates the ceiling, floor, attic or roof systems must be of type B, BW, or type L. The appliance vent shall extend in a generally vertical direction water heater drain pan.
Frico offer a wide range of water heated fan heaters that fit every need. to recess the fan heater into a suspended ceiling. Good quality, lower price Extension collar SWTCE 1) Fan heater SWH/SWS 2) Mounting brackets SWB 3) Basic filter SWFTN
Direct Vent Gas Water Heater. ceiling without provisions for removable panels for inspecting or (10.2 cm) diameter telescopic tube and plenum collar until seated on top of the plenum box. Drill three (3) 1/8 inch (3.2 mm) diameter holes, 120o apart, through the six (6) inch (15.2 cm
And Water Heater operation or if there are any damaged or missing parts when you unpack this unit from the shipping box. Please call before returning to the store. 1-866-946-1096 Fill 3.0 oz. of water through the exhaust collar per figure 1.
Vent pipe enters the ceiling. The other opening should be near the vent termination. water heater collar. Exhaust Flow 5.0mm hole for Stainless Steel Screw High Temp. Sealant (applied underneath trap) Collar Condensate Trap 9301PAL Vent Adapter Clamp
Joining methods from different manufacturers beyond the flue collar The Z-FLEX SPECIAL STAINLESS VENT SYSTEM is for use only with appliances having a positive vent pressure of 8” of water E. Vertical runs must use a fire-stop as a lateral support at each ceiling level and at least
Duct.Collar.Dimensional.Data capacity.of.a.cabinet.unit.heater.at.any.water.temperature.and.entering.air.temperature,.then.apply.the.correction.factor.from.the. Wall or Ceiling Model CW, Sizes -14 Steam/hot Water Cabinet Unit heaters approx.
That will project at least 6” below the finished ceiling before installing the roof jack assembly. collar of the water heater, see Figure 16 on page 12. 12 FIGURE 16. 7. Extend the flue pipe down close to the water heater flue collar, see
NOTE: A fire stop must be provided when a vent passes through a combustible floor or ceiling. The to the exhaust collar of the water heater, be sure to form a tr ap by means of a 3” (76.2 mm) loop filled with water. This
Collar width is 1” for securing ductwork and is located at the bottom water cabinet unit heater: > Room Heat Loss (Btu/hr) Ceiling Recessed Average Water Temp. = 160°F > What is the maximum mounting height?
Water Heater Replacement (Residential bottom of the closet and the other within 12 inches of the ceiling. GAS SUPPLY Gas-fired water heaters shall be connected to the house gas line with an pipe and double wall Type “B” flue pipe shall be done with an approved transition collar.