As an automatic circulating tank water heater; and for operation on combustible floors and in alcove installations. All models are North Carolina Code compliant. CLEARANCE TO COMBUSTIBLES (inches) MODEL NUMBER SIDE REAR TOP GP100-200
water heater is on the 1st floor. Minimum 6 inch clearance to combustibles. Min. pitch ¼ inch per foot. 10. Gas Connector (Gas Water Heaters Only) Accessible and approved valve with maximum 3 feet of flex connector. Connector and valve must not be
clearance to combus-tibles. Class B vent or con- chimney, with a minimum ¼-inch pitch up to the flue. Water heater must be listed and labeled and one-inch clearance to combustibles Metalfire stop device
Water heater not located in bedrooms, bathroom, Single wall metal vent connectors a minimum require clearance to combustibles of 6” (CMC Table 3C)-. Vent connectors are for exposed areas and not for use in attics or crawl spaces.
Water Heater Replacement Inspection Checklist Page 1 of 1 Water heaters must be installed with the clearances from combustibles prescribed by the manufacturers installation instructions and listings clearance to controls.
0˝ clearance to combustibles, approved for installation on combustible ﬂoors The water heater control system will display detailed diagnostic information on the LCD screen to help service technicians quickly locate and correct the problem. 5.
Gas Water Heater Installation Instructions and Use & Care Guide 6510418 Maintain required clearances to combustibles. Keep combustibles such as boxes, magazines, the specific clearance locations. A minimum of 24
All The Commercial Water Heater Choicesou Y Need! For new construction or replacement applications, State . , with 0” clearance to combustibles, top-mounted gas and electrical connections, plus the versatility of standard power
– ASHRAE 90.1-1999 Compliant – Zero Clearance to Combustibles – Factory Installed T&P Valve – Factory Provided Condensate Trap Water heater(s) shall have a nominal storage capacity of _____ gallons and a recovery rate of
GAS WATER HEATER REQUIREMENTS PERMIT REQUIRED: Maintain 4-inch clearance above WH controls. 10 Vent A double wall vent must be provided with a min. 1 inch to combustibles. Min. 5 feet vertical required between vent collar and vent cap.
A water heater permit may be issued only to State of California Licensed Contractors, clearance to combustibles and cannot extend into enclosed framing, attics, or roof areas. The transition between single wall vent and double wall Type “B” vent shall be done with an
Typical Installation of Water Heater • Shed clearance to property line is 3-feet. Verify approved location with Planning Division.
Gas Tankless Water Heater Engineering Submittal Sheet 660 EFO Performance Data Maximum Gas Input (BTU) 140,000 Minimum Clearance to Combustibles (Inch) Front 24 Rear 0.4 Side 6 From top edge of exhaust to overhang 36 Additional Information
Clearance to Combustibles • Approved for installation on combustible flooring. All Controls Including Gas Valve and Combustion Air Blower Water heater should incorporate the iCOMM™ system for remote monitoring, leak detection and fault alert.