Minimum Clearance for Servicing 18" from top, 24" from front, 4" sides and rear. Water Supply Pressure 150 PSI maximum allowable working pressure. Plug water heater into wall outlet. Step 11. To resume operation follow the lighting instruction
water heater installation manual. The entire installation must conform with the specifications clearance from exterior wall to tee terminal as indicated in Figure 6. 3" sealed stainless steel (AL29-4C) exhaust pipe Concentric vent kit
Maintain specified clearance to combustibles on the wall where the appliance is installed and any adjacent walls or overhang. Observe all provided with the water heater to a wall surface. See Fig. 8. B The installation method of the mounting bracket will
Tankless Water Heater Recess Box clearance to combus-tibles. For service and proper operation, 24” (61 cm) of must be sealed to prevent water infiltration in to the wall. Fail-ure to do so could result in damage to the wall.!
WATER HEATER INSTALLATION • Insulation is required on all hot water pipes. • If wall studs are not properly located to allow adequate anchorage, 6” Min Clearance to Combustibles Cold Water Shut-off valve on incoming water line
Maintain specified clearance to combustibles on the wall where the appliance is installed and any adjacent walls or overhang. Observe all provided with the water heater to a wall surface. See Fig. 9. B The installation method of the mounting bracket will
1”clearance to combustibles for B vent or per Single wall vent is not allowed in attic or concealed space Vent connector requires 3 screws at each Water heater installed in a residential garage shall be installed so all burners
GAS WATER HEATER MODELS SW6D • SW6DE • SW6DM • SW6DEM Minimum clearance from combustible construction on sides, top, floor and rear = 0 inches. B. Secur e t he con trol housing o t coach wall (f amed opening) at op and
Water heater not located in bedrooms, bathroom, clothes closet or closets openings into Double wall type B vent has at least 1” clearance to combustible materials. [Table 8-2] Combustible clearances per appliance nameplate or manufacturer’s listing.
Outside wall through which the water heater vent is going to be installed, and as centralized with the water piping system as possible. Is there proper clearance between the water heater and anything that might catch fire?
Heat Pump Water Heater Form. Zonal (window and/or wall units) Evaporative cooler. Number of occupants: Number of water heaters: There is adequate clearance to remove the air . filter . Earthquake strapping is installed .
All water heater installations and replacements require a building permit A single wall vent connector must be fastened with three sheet metal screws, Please note the front clearance is usually greater than the side and rear.
Instantaneous gas water heater Models CLEARANCE The WR400-1 is design certified for installation on a The heater must not be installed on a carpeted wall. The heater must be mounted to the wall using appropriate anchoring materials.
One penetration point through the exterior wall or roof for both combustion air and exhaust vent piping. Complete tankless water heater installation per the water heater’s installation manual (Fig. 6 and clearance above highest anticipated snow level. maximum of 24 flashing (field in
WALL CONNECTOR WATER HEATER CONNECTOR RISE LATERAL TOTAL VENT HEIGHT FAN ASSISTED FURNACE WATER HEATER WITH DRAFT HOOD Fig 3 B-VENT WYE. 5 Firestop Supports are currently manufactured for pipe sizes of 3" through 12" WALL STRAP 1 INCH MINIMUM CLEARANCE TO
Side-wall vent terminal for indoor unit with horizontal venting PNCV (Water Heater) Clearances Appliance Required Clearance From Suggested Service Surface Combustible Material Access Clearances Left Side 1 2.5 24 61 Right Side 1 2.5 24 61