Water Heater and /or Date: 12/9/2010 Triangle Tube for the installers which water fill or make up water supply line. – For installation in Massachusetts all direct vented appliances must comply with the guidelines as outlined on page 10.
To Fill the Water Heater Make certain that drain valve is closed, then open the shut-off valve in the cold water supply line. Pilot tube pinched or The pilot should be cleaned, repaired or replaced by a clogged. qualified service technician.
AG Series Vacuum Tube Solar Water Heater User Manual Please read the manual carefully before use and retain for later reference Contents: Continue to fill the cylinder with cold water until water comes out of the top of the vent pipe.
Non Pressure Evacuated Tube Solar Heater – Auto Fill Characteristics Reliable & cost effective Stainless Steel SUS304 -2B Inner tank transferred directly to water flowing in the Vacuum tube. This heat is then transferred by means of thermosiphon to the tank. No circulation pumps are
Once programmed, the system automatically starts the water supply at the defined time to fill up the water in the solar tank and cut off the supply once the tank is filled up automatically. o M an u HAIER VACUUM TUBE WATER HEATER
Fill out and keep with water heater. IMPORTANT INFORMATION (Re)install the condensate tube. CONDENSATION WARNING: THIS WATER HEATER IS A CONDENSING UNIT AND REQUIRES A DRAIN TO BE LOCATED IN CLOSE PROXIMITY TO ALLOW CONDENSATE TO DRAIN SAFELY.
Fitting is a plastic fill tube. Its purpose is to enhance water circulation. DO NOT REMOVE PLASTIC FILL TUBE. IMPORTANT: water heater temperature will be regulated by the thermostat. TO TURN OFF WATER HEATER 1. Turn switch to “OFF” position.
The solar water heater uses energy from the Sun to heat water. Your task is to find out how hot the Carefully fill the tube to the top with cold water. Put the stopper back in the metal tube. Put the tube and metal fin back
Lic dip tube. ICE ICE Chart 1 Water Heater Model Connections (Inches) Recirculation Dip Tube Draining Dip Tube Recommended Minimum Domestic Boiler Piping Water fill with water. 5. When tank is full, air will stop escaping, and the automatic air vent will close. If air vent
If you have an electric water heater, tube when doing this – it is important for the tube to rest on the bottom of the tank. If the water level is about the same, you can fill the brine tank with salt or potassium chloride.
Pilot tube, the igniter wire from the igniter button, the 4. Fill the tank completely with water. NOTE: To purge the lines of any excess air, keep the the water heater or on the front cover of this manual. Figure 29
To Fill the Water Heater Make certain that the drain valve is closed, then open the shut-off valve in the cold water supply line. Open each hot water faucet slowly to Pilot burner tube pinched or The pilot burner should be cleaned, repaired or
water heater’s output is limited by its heating capacity, measured in Btus per hour. Cold water from street Intake filter Dip tube ensures that tank fills from bottom, giving cold water time to warm. Thermostat is hard-wired to power supply.
Manifold tube. 4. Fill the tank completely with water. NOTE: To purge the lines of any excess air, keep the hot water faucet open for 3 minutes after a constant flow of water is obtained. 10 Fill the system with water. 11 Turn heater fuel “ON”.
GAS WATER HEATER INSTALLATION, OPERATING allow tank to fill up with water and check connections for leaks. To ensure complete filling of Cold water supply nipple 5. Dip tube 6. Hot outlet nipple 7. Draft hood 8. T&P valve 9. Drain valve 10.
Activity 3: How to build your own – Mini Solar Water Heater (Primary Schools) Parts list 12mm ply panels: With a stopper in one end of the copper tube, fill the tube with cold water d) of water in the tube is quite small