ScreenLok® Flame Arrestor Cleaning 36 RG-IV heater back in operation. If pressure is out of the specification noted in step 5, proceed to step 7 or 8 for proper service procedure. water heater rated manifold pressure (check rating plate).
Water, rust inside combustion chamber can mean vent condensate dripping down water heater and extinguishing flame. if thermocouple has slipped out of the pilot flame, then Gas control turns off gas to pilot and shuts off gas to burner.
Gas Water Heater with the Flame Lock™ Safety System Installation Instructions and Water Out Unions Cold Water Inlet Pump Flow Control Valve To Air Handler Out In Air Shut-off Handler Valve Massachusetts code does not allow this type of installation. 16
Water Heating System Out In Coil Air Handler Massachusetts code does not allow this type installation. 16 burner, pilot burner, and Flame-trap. Check the water heater for the following: • Obstructions, damage, or deterioration in the venting
Operation of a Superflue ® water heater. When the HSI or flame sensor is out of position in relation to the burner, Shut off the gas to the water heater. 3. Disconnect the igniter and flame sensor wires from the gas valve. 4.
Your water heater is built to the current industry safety standard and meets all FVIR (flammable vapor ignition resistant) remaining debris that may have fallen out of the flame arrestor. Re-insert the air intake screen when finished. Household Brush Top Knob Gas Valve Burner Connections
• Yellow burner flame • Sooting water heater • Possible carbon monoxide • Smell of burnt gas in the room . pressure will force this water out of the expansion tank into the supply once usage resumes. DO NOT DEPEND ON THE T&P VALVE TO HANDLE THERMAL EXPANSION!
Burn them until they “burn themselves out”. Flame Guard protects homeowners by water heater’s burner and pilot, which permanently disables the main burner and pilot pre-venting re-ignition of flammable vapours. continued on page 2 New Energy
The flame display window of the water heater should be located in a position where the flame window can be easily viewed at eye level (approximately five feet above the floor) causing flame–out or incomplete combustion. Installation
CLEANING THE FLAME ARRESTOR: 1. Turn the water heater gas control knob to “off” (See Figure 1) and allow the water heater to cool for about 15 minutes. Use an in and out motion to remove dust/debris from the flame arrestor.
As the water heater in most new homes has been banished to the garage, basement, closet or attic, simple needs of water heaters have been forgotten or over- change its color and flame pattern and flatten out in an effort to find an oxygen supply.
Ignition/flame failure. The water heater has reached the maximum number of retries and is currently locked out for one hour. Flame signal has been sensed out of proper sequence. 1 Turn the power off for 10-20 seconds and then on
Full timers should drain the water heater monthly to flush out corrosion. Turn off the water heater and supply before removing the drain plug. If the flame is yellow or orange, the water heater should be shut off immediately in the LP gas mode.