Not be suitable for water heater installation. • Water heaters installed in open spaces in buildings with Provide ventilation to water heater. Check flue way, flue baffle, and burner 2. Clean flue, locate source and correct 3. Check with gas utility company 4.
Instantaneous Oil-Fired Water Heater Installation Manual MODEL OM-180 CONTENTS IMPORTANT THIS APPLIANCE SHOULD BE INSTALLED BY A LICENSED, AUTHORIZED PERSON(S) DUE TO THE Do not install the flue pipe below the water heater. 6.
Flue Installation (R98LSi 32 VA Series Indoor LS Manual Air Intake Assembly The installer is responsible for your water heater’s correct installation. Please complete the information below to keep for your records: Purchased from: Address: Phone:
Complete the rest of the vent pipe installation to the water heater’s flue outlet and air intake. 1 3 2. 42 Venting INSTALLATION INSTRUCTIONS Venting for Direct-Vent Water Heater (cont.) Alternative Horizontal Vent Installations Exhaust Vent Pipe Air Intake Pipe Inspection
Water heater is certified for installation on a combustible floor (see Figure 1). – 2 – WARNING and water heater™s flue tube reducer must be hi-temp red silicone or other material suitable for 315°C (600°F) con-tinuous service. Figure 3H
Up the exhaust flue products from the water heater and return them to the building. This can create a health hazard. 8. After installation of the water heater is complete, purge the water line to remove all the debris and air from the line.
Part of the continuous flow water heater. The following flue type and make is approved in combination with above mentioned water heaters. Improper installation of flue systems and components, or failure to follow all installation
MULTIPLE WATER HEATER FLUE INSTALLATION Where multiple water heaters are installed, each water heater must be individually flued to the outside. A common flue system MUST NOT be used. For a multiple unit installation, the water heater is certified for installation with zero clearance between
OIL FIRED WATER HEATER INSTALLATION AND OPERATING INSTRUCTIONS practiced in which the water heater flue enters the chimney above the main smoke pipe. Also, a “Y” fitting is frequently used to combine the heater and furnace flues, prior to enter-
Flue Installation As this water heater is flue type, the waste gas exhaust pipe must be installed. (Unless you are using this heater outdoors in the open) (Fig. 9) Basic requirements: The inner diameter of the flue: ∮90mm. (3.54 inches)
– 1 – Vent (Flue) Terminal WARNING Icons warning of risk level: CAUTION This symbol warns of hazards which have the immediate poten-tial to result in severe or lethal personal injury or fire.
150158 rev. 2 august – 2010 operating, installation and service manual commercial gas water heater with flue damper and electric ignition system without fan motor