To the “ ” (off) position and then turn off the isolation valve on the gas line to the water heater. Leave the area and call Rheem Service or a qualified service technician. D. Use only your hand to turn the gas control knob, never use tools.
If your gas supply is LP gas, your water heater can be converted to burn LP gas as follows: 24 Turn manual gas shut off valve to the ON position and light the water heater as outlined in this manual. Leak test all gas connections and caps with soap/water
Tankless Water Heater Installation Kit Drain Port Handle PR Valve Discharge Line Hot Water Distribution Pipe Gas Connector Nut Adapter Coupling Nut Thread adapter fitting into gas ball valve and other adapter fitting onto appliance gas inlet. 6.
This gas-ﬁ red water heater is design certiﬁ ed by CSA International under American National Standard/CSA For safe operation of the water heater, the relief valve must not be removed from its designated opening nor plugged.
Turn on the gas shut-off valve(s) to the water heater . Use a soapy water solution to test for leaks at all connections and fittings . Bubbles indicate a gas leak that must be corrected .damage, personal injury, The factory connections should also be leak
GAS WATER HEATER TIMER INSTALLATION INSTRUCTIONS Congratulation for purchasing the Gas Water Heater Timer. Our ‘SmartDevice’ comes YOUR CONTROL VALVE FROM YOUR WATER HEATER! FIG D 3 Seat the Gas Water Heater Timer firmly onto the face of
SERVICE PROCEDURERG-V Gas Valve Testing and Replacement (White Rodgers/Robertshaw) The gas valve is a non repairable device. If trouble shooting has determined a problem with the gas valve, it must be
About the WAGS Valve WAGS stands for Water And Gas Safety valve. The WAGS valve is designed to shut off the water supply to a water heater in the event of a water leak, minimizing property damage.
Into the water heater base. In addition, a thermal cutoff (TCO) device, is designed to shut off gas flow to the burner and pilot if poor combustion is detected. 1/2" GAS CONNECTION VALVE C COLD CONNECTION E HOT CONNECTION ANODE ROD* *Location for optional top-mounted
Residential gas-ﬁred water heater(s) shall be a direct/pwoer vent Polaris model_____as manufactred by American Water Heaters and shall have a 10-year limited tank The gas valve shall be a Honeywell CV1-r1 series gas valve with a matching 45.900 series venturi manifold using a 1:1
OPERATING YOUR WATER HEATER White Rodgers Gas Control Valve/Thermostat – Lighting Instructions FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: FLAMMABLE If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal
This instruction has been prepared to acquaint you with the service of your gas– ﬁ red water heater. It is your responsibility to ensure that your water heater is properly installed and maintained. GAS WATER HEATERS GAS VALVE REPLACEMENT
PREMIUM ELECTRONIC GAS VALVE Commercial Grade More Reliable Robust Thermopile Integrated Igniter – No Manual Lighting of the Pilot automatically shut down the water heater if air supply becomes restricted or overheating threshold is reached
Lighting the Gas Valve This water heater has a new, advanced gas valve and lighting the pilot is different than on older models. To light the pilot, follow the lighting instructions on the water heater’s
Adjacent to the gas control valve on the water heater. WARNING A gas water heater cannot operate properly without the correct amount of air for combustion. Do not install in a confined area such a closet, unless you provide air as shown in the “Locating
Http://waterheatertimer.org/How-to-troubleshoot-gas–water–heater.html . The Bradford White Disconnect gas supply line from gas valve. Step 4. Turn off water supply and drain water heater completely. Step 5. Remove outer jacket burner access door.
The water heater's gas valve (D). CAUTION: Do not use teflon tape or other sealant on any of these connections. 2. Screw provided gas valve adapter (E) into gas valve (D). 3. Re-insert thermocouple (C) into female thread of gas valve adapter (E)
GAS WATER HEATER INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTION MANUAL – Do not store or use gasoline or other the water heater, pressure relief valve or related fittings where adequate provision to drain such water has not been made.
Water Heater Troubleshooting Standard gas and electric water heaters use an insulated storage tank. Water heaters are generally very reliable but on occasion, they do have problems. • Replace the gas pilot control valve
Before spending money on repairs, check anode rod. Open drain valve and drain water heater. If there is rusty water, then check anode If anode rod is depleted, then install new anode to prevent steel tank from rusting.