Combi2 ª Gas Water Heater CDW2 Series 5 Cold Water Inlet Dip Tube Polysulfone 229-39628-19 6 Plug Type Anode Aluminum 224-38508-03 7 T&P Relief Valve 230-40594-02 8 Wire Tie 239-44328-00 9 Right Side Inner Door Complete 239-43963-07
Make sure that any shut off valves to the heater (on the cold water inlet side) are in the open position to allow water to fill the heater. The inlet guide seal is located on the inlet guide that fits over the upper inlet water tube. It will be
Tap Water Inlet Prevent Denting Valve Mixed water valve Shower This type of solar water heater ( SWH ) is a pressure one. We use the vacuum 4.A. Split Solar Water Heater with the U pipe Tube: ф47×1500mm vacuum tubes with the U copper pipe inside
• Self-Cleaning turbulence inducing cold water inlet–tube engineered to diminish hard water area sediment deposits. THIS WATER HEATER MEETS THE REQUIREMENTS OF ASHRAE AND MEETS OR EXCEEDS THE THERMAL EFFICIENCY REQUIREMENTS
N Cold Water Inlet O Inlet Dip Tube (Not Shown) P Temperature-Pressure Relief Valve Q Rating Plate R Flue Bafﬂ e S Gas Control Valve/Thermostat T Drain Valve U Pilot and Main Burner V Flue the water heater or air inlet. Vent Pipe System
Ting adapter to cold water inlet of heater. It is imperative that no heat be applied to the cold water inlet, as it contains a non metal-lic dip tube. ICE ICE Chart 1 Water Heater Model Connections (Inches) Recirculation Dip Tube Draining Dip Tube Recommended Minimum Domestic Boiler Piping
Indirect water heater stainless steel cold inlet dip tube . large smooth wall heating coils . removable thermal well . all connections on top on models 30 thru 115 units all stainless steel construction t+p valve and drain are factory installed .
water heater; and two, for the owner–operator, tube and/or heat traps. Refer to the illustrations on pages 8 and 9 inlet water line.It may have been installed in the cold water line as a separate back flow preventer, or it may be
Glass Tube Water Heater ( Evacuated Tube Collector “ETC” ) Horizontal stay channel Vent support Right hand, Cradle equipment to the cold water inlet line of the solar water heater. 3. Do not use a pipe-wrench. If the system has to be disassembled and
tube engages in the slot of the bracket inside the combustion chamber (Figure 29). correctly sized pipe into the inlet and use it to turn the gas control valve/thermostat (counterclockwise.) the water heater or on the front cover of this manual.
The water heater adopts liquefied petroleum gases or liquefied natural gas as fuel. The combustion reaction occurs in the combustion chamber, which is The K-type thermocouples are placed at the inlet and outlet tube of air and water sides.
IMPORTANT: This water heater is supplied with inlet and outlet heat traps to help conserve energy. Do not apply heat to the hot nently damage the dip tube or heat traps. 3. RELIEF VALVE- A new combination pressure and temperature re-
Water Heater Troubleshooting • Undo cold water inlet and pipe nipple and remove dip tube. Check condition and replace if required. • Check for crossed connection by turning off water supply to water heater. Open hot water tap at a faucet.