Can reduce the likelihood of water entering the heater, but this does not provide a fully Turning the power to the heater on and off on a cycle that allows the resistance then keeps it off long enough to become cool.
Thermostat" or "Off", or turning the Auxiliary equipment on or off. (For normal operation, REMEMBER TO TURN OFF THE HEATER SWITCH WHEN YOU ARE THROUGH HEATING. Keeps the pump off. This means the pump cannot be turned on by the SPA/POOL switch,
This will fill the spa through the heater, Turn the power to the spa off by turning breakers off or unplug from the wall. Water must have Sanitizer added within 36 hrs of the spa being up to temperature and before use. Weekly Care
Limitations of the water heater. Turning up the temperature of the water This keeps standby losses low while providing an can’t sleep), hence part of the need for timers to turn off the pump. This
Insulate the shower water heater to further reduce water heating costs. EFFICIENT OPERATION lowering the temperature or by turning off the heater. Turn the temperature down, but keeps damaging moisture from getting to the
Turning the light on: Setting water temperature: Automatic water heater start: speed and keeps blower on, a fourth time turns blower off and The heater is automatically turned off when the pump is
heater from turning on for two minutes after the set point has been reached. If the time delay is F0 Heater locked off, thermistor If water temperature reads wire disconnected or water greater than 0°C, phone for at 0°C (freeze conditions).
Apply soapy water to connection, look for bubbles, • CAUTION: After turning heater off, wire guard will remain hot. If Heater keeps shutting “OFF” during normal operation. CHECK • Pilot is blocked – clean pilot, see MAINTENANCE.
The water heater. Turning up the temperature of the water element without increasing tank size. This keeps stand-by tick as they warm up and knock when the faucet is shut off. Water hammer seems to have been solved, although you
Temperature level by turning the heater ON and OFF. NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. other water container. 6. Extreme caution is necessary when any heater is used by,
Closest faucet and/or hot water heater drain and furthest faucet If pressure drop from the well pump shut-off setting (the 60 psi in a 40-60 psi setting) at the furthest faucet is greater than 65%, air separation may occur within plumbing system.
This keeps them from going into heater controls. If sediment trap is not installed or is installed wrong, der water. Shutting Off Heater 1. Turn control knob clockwise Turning control knob to HI position when burners are cold 2.
The water heater to plug off the unused fittings. Ensure that a sealing material is applied to the plugs to prevent leaking. with water before turning on the electricity supply. Electrician: Press the reset button on thermostat to ensure over-temperature
Piping connection is made from the geothermal unit to the water heater. must be turned off when water flow from the water heater to the unit is The unit lockout indicator light will remain on for up to 15 seconds after turning the system off. 3.