Water Heater for more information on changing settings. START UP 31 before the alarm condition can be cleared. The Leak Detector will air dry over time or can be dried manually when disconnected. • See Warning in first column if there is water on the
Audible alarm No recurring costs The 513 Alert Auto Dialer offers these unique features: How It Works 1 Wireless sensor informs 2 Ever had a water heater leak? Concerned that the washer could overflow? Furnace ever gone out? AC break down? Power outage?
Replace your water heater before it breaks down and install a leak detector to avoid water damage. It’s a lot of work to maintain a A water leak detector finds leaks, sounds the alarm and automatically shuts off the water intake valve. It can even be connected to your home alarm system.
alarm inside the FloodRing® can alert you to a leak. When the water heater leaks, and drains the water away or sounds the alarm. OVER. o matter how many times we are reminded, people always forget to shut off the water valves when
Any water – you probably have a leak and Check for Water Heater Leaks Little Leaks Can Mean Big Problems Most people visit their water heaters only if the hot water stops. Check yours. fire alarm batteries around the house. Also operate the
An alarm when water flow during a given time exceeds the normal flow programmed for that time. If normally be dry, such as the floor beneath the heater. When a leak or overflow activates the sensor, the shut-off valve closes automatically to stop the flow of additional water into the system
• Sensors mounted in the drain pan that trigger an alarm or turn off the incoming water to the water heater when leakage is detected. water heater’s temperature-pressure relief valve is reached, may be diagnosed as a “tank leak”. After the water in the tank warms up (about 1-2
Mounting plate activates an alarm when contacted by water. Code Approvals-UL/CUL 499/64, HUD Mobile Home, ISRAEL, NOM, and NEC. Heater(s) shall have a built-in water leak detector. All water passages must be constructed of a high
Will occur from the water heater firing if it is not isolated prior to performing the pressure tests. b. Test the Leak Defense System Alarm Open a faucet so the “Flow Rate Exceeded” lamp on the front of the control panel stays on.
MUTE button = Press to silence alarm (valve stays closed) Reset Sequence (After Cause of Use pipe sealant or Teflon tape for NPT/water heater applications. Tip: Place the water/leak sensor at the base of the appliance.
(Rev.1 – 01/20/05) 6.2.17 – Gas and Carbon Monoxide Leak Detection and Alarm Systems Page 2 of 3 energize the exhaust fan in the Gas Meter Room. water heater, between the boilers, and adjacent to gas-fired equipment (unit heaters, duct
Self-contained heater to avoid nuisance alarms of WD-RS Connect the 2-core leader cable to the WD-AMX alarm module and terminate at the sensor input (polarity You can test the cable by placing a wet cloth over the cable to simulate a water leak, the relay will come on.
You might not be the only one looking forward to your vacation. Theft increases during the summer months largely because vacant homes make for an easy target.