And leak. Any water heater should be installed in such a manner that if it should leak, the Smelly water could be due to an unusual reaction between local water and the heater’s anode rod. Check anode rod (see section on changing the anode rod). 1.
The water heater should be located as close to or centralized to the Anode deterioration depends on water conductivity, not necessarily spud area. Remove valve* if leak is indicated and repair with pipe joint compound.
American HCG Series The HCG Series High Efficiency Commercial Gas Water Heaters embody all that automatically adjusts the anode protection depending on the water conditions avoiding an emergency leak Provides detailed heater status information
†A replacement water heater should the tank leakafter original installation. You will be responsible for any labor, in-home service, shipping, removal, disposal, by operating the water heater with the anode rod removed.
Gas Leak Testing Important: This water heater and its gas connection must be corrosion and prolonging the life of the water heater. Once the anode is depleted, the tank will start to corrode, eventually developing a leak.
9.Failure to service the anode rod at least once a year could cause the tank to fail and leak. IMPORTANT SAFETY INSTRUCTIONS Warning KEEP Smelly water could be due to an unusual reaction between local water and the heater's anode rod. Check anode rod. Water is too 1. Turn the temperature
New water heater for one that develops a leak. check for water leaks around powered anode rod and immediately correct any if found. 13. Upon determining there’s no water leak at the newly installed powered anode rod, reconnect the electrical plug connector
This water heater and its gas connection must be leak tested before placing the water heater Magnesium Anode-Hot Water Outlet 20. Heater Leg 7. Dip Tube-Cold Water Inlet 21. Thermocouple Lead 8. Temperature and Pressure Relief Valve 22.
Should leak, the water flow will not cause damage to area near water heater, or to lower floorsof structure. When such Magnesium anode — The water heater is equipped with a magnesium sacrificial anode. The anode may erode over time
In every water heater there is an anode, usually composed of zinc or magnesium, which will most likely corrode before the tank begins to corrode. leak detector. All gas-fired units should have a drip leg where the gas line enters the water heater.
To leak a small amount of water during heating cycles. anode (supplied in the heater) may become over-reactive. Inside the water heater carton you will find a warranty card – please fill in the details and return immediately.
Your water heater includes an anode rod that protects it from corrosion from the potable water. It also should be checked at least every five years. insurance against a water leak anywhere in the house, having nothing specifically to do with solar heating.
Each water heater contains at least one anode rod, which will slowly deplete (due to electrolysis) prolonging the life of the eventually developing a leak. Anode Rod Depletion FIGURE 20. Certain water conditions will cause a reaction between the
Prevented by a leak detector or water shut-off device used in conjunction with a piped metal drain pan. water heater tank. The anode rod should be removed from the water heater tank every 3 years for inspection. The following are typical
Gas Leak Testing Important: This water heater and its gas connection must Anode Maintenance Your water heater has been supplied with an anode rod that protects the tank from corrosion. As the rod works, it slowly