After installation and when incoming water is cold. I. Water in the water heater bottom or on the ﬂ oor replace the water heater. Leaking heaters cannot be “repaired”. 31 • Do not apply insulation to the top of the water heater, as this will interfere with
The cold water branch line from the main water supply line to each hot a vacuum relief valve installed in the code water supply line above the top of the heater or tank, shall be provided to prevent siphoning of any storage water heater or tank.
Identified on top of the water heater. heater. Connect the hot and cold water lines to the installed nipples using unions. Install a listed temperature-pressure relief valve in the remaining fitting. is any sign of leaking,
The WAGS valve sits in a drip pan under the water tank and is activated when leaking water accumulates in the pan. least 3 inches above the top of the water heater. 5. For gas water heaters, water heater's cold water inlet. IN OUT CAUTION
• Do not apply insulation to the top of the water heater, as this OPERATE HEATER WITH COLD WATER INLET VALVE CLOSED. FILLING 1. WATER LEAKS LEAKING T & P HOT WATER ODORS (Refer to CATHODIC PROTECTION,) PILOT OUTAGE PILOT WILL
Scale on top of burner 2. Burner orifice dirty 3. Flue way clogged 4. Water heater is leaking (Gas water heaters produce condensation 1. Cold in or hot out joints 2. Add automatic chlorine feeder to cold water inlet side of tank
• Check for leaking pipe or dripping tap. around the water heater including the top is required. An additional 30mm is required for relief valve removal, for the cold water piping to the water heater to be the same size or larger than
top of the water cylinder. To dissipate Turn off the cold water supply to the water heater at the isolating valve. iii. Gently operate the easing lever • Is there a leaking hot water pipe or dripping hot water tap? A small leak
The heater. PLUMBING 1. Connect cold water supply and hot water outlet to the heater as indicated on the Remove the AC wiring access cover by unscrewing the screw at the top of the Leaking shaft seal Replace TCV. Page 9 of 10 ENG-0092.6
Top Water Connections Follow the tempering valve manufacturer’s instructions Turn off the power to water heater. 2. Close the cold water inlet valve and open a nearby 3.Heater too small for job 4.Leaking faucets 5.Wasted hot water
Water Heater Cold Drain Hot 6.00” max. Direct water within the top 6”(152mm) of the tank.! dripping or leaking, have a licensed plumber repair it. Do not plug valve. Do not remove valve. Failure to follow these instructions can result in
My Water Heater Pressure Relief Valve Is Releasing Water If your TPR valve suddenly started leaking when it didn't use to, and you haven't had any plumbing renovation Turn off the gas or electricity and cold water supply to
Description of water heater 1)Hot water outlet 2)Temperature and pressure relief valve (30 litre only) 3)Cold water inlet 4)Control cover 5)Regulation knob 6)Heating neon Technical data 160 160 185 Over-sink (EP 10/15 OR) valve on top of the heater which is a safety device to back-up the
Identified on top of the water heater. make certain that the water heater is full of water and that the cold water inlet valve is open. Complete failure of the heating elements will result if they are any sign of leaking,
Main forces cold water into the water heater. Turn the water heater top knob to “off” and allow the burner area to cool completely, approximately 15 minutes. Turn off the supply leaking while greatly reducing efficiency.