Water Heater SAFETY TANK Water Heater Owner’s Manual and Installation Instructions For Models leaking or flooding and/or property damage. Use only with potable water system. Connection G-5 2.0 150 200°F 40 8" 12 5/8" 3/4" NPT
Water Heater Cold Drain Hot 6.00” max. Direct the same size as the valve discharge connection throughout its entire length.! Excessive length, over 15’ long (4.57m), dripping or leaking, have a licensed plumber repair it. Do not plug valve.
Onto the hot water outlet connection of the water heater. Installation is complete. Operation: 1. CAUTION! Before pressurizing the system for service, ALWAYS make sure the drain valves of both HOT and COLD isolation valve assemblies are placed in the CLOSED position,
CAUSE Water accumulating on the floor or in the drain pan is generally caused by one of the • Drain valve leaking – Check to see if the heater drain valve is closed tightly. • Leak at gas valve threaded connection
Electric Water Heater OWNER’S MANUAL FORCE 10 MARINE COMPANY 23080 HAMILTON ROAD RICHMOND, BC CANADA V6V 1C9 TEL: (604) 522-0233 FAX: (604) 522-9608. Page 1 of 10 Leaking from TCV Connection Loose Connection Tighten the collar hex nut on the TCV.
leaking toilet loses water from the tank to the bowl without being ﬂushed. How to Conserve Water • Install a 1.6 gallon toilet • Buy a water-efﬁcient washing machine • Repair leaks • Reduce water use in the yard and garden • Wash full loads
IMPORTANT: This water heater and its gas connection must be leak tested before placing the appliance in operation. Do not assume the water heater is leaking until there has been enough time for the water in the tank to warm up.
Loose wire connection 7. Incorrect sizing 8. Incorrect plumbing (cold going into hot connection) 1. Carefully observe source of water leaking from heater. 6. Tape clear plastic to floor around water heater; Observe for several days.
A leaking water heater would always have water on the floor and never dry up over time. TECHNICAL SERVICE DEPARTMENT Technical Service Bulletin 1-800-432-8373 connection, or T&P valve? No Go to question #8 Using a flashlight, examine the
・ Check for cross connection between cold water lines and hot water lines. For indoor models, check if condensate drain is installed on the vent collar of the water heater. 3. Check if there is leaking from heat exchanger (Part #401).
Improperly sealed, hot or cold supply connection, Tighten threaded connections. relief valve, drain valve, or thermostat threads. Leaking water heater/ leaking TP valve http://waterheatertimer.org/Leaking–water–heater.html Smelly odors
* Water heater dimensions prior to installing insulation blanket that is included with water heater. WATER CONNECTION ANODE ROD RELIEF VALVE CONNECTION 8" WATER CONNECTIONS ALL 3/4" N.P.T. E ner gyF ac to d Av ulOp i Costs based on D.O.E. (Department of Energy)
Mayor Michael Nutter said Tuesday it would be "pure speculation" to say a contractor's cigarette caused a gas explosion that leveled a Philadelphia home, injuring eight people.
The hot water connection is also identified at the top of the heater. Install a shut-off valve in the cold line approximately 1m by water leaking from the water heater, pressure relief valve, or related fittings. Select a location as centralized
・ Check for cross connection between cold water lines and hot water lines. check if condensate drain is installed on the vent collar of the water heater. 3. Check if there is leaking from heat exchanger (Part #210 or 211). 741:
Poor thermocouple connection 8. Air in gas line 9. Thermostat’s single use ECO is tripped 10. Gas valve defective Water heater is leaking (Gas water heaters produce condensation 1. Cold in or hot out joints 2. T&P valve Check joint and repair
water line pressure to prevent any water from leaking out of the pipes while making the water connections to the water heater. suction connection. Connect the outlet of the pump to the inlet of the this water heater to obtain increased temperature water required by these
Joints from leaking. After you have re-assembled the gas joint compound or Teflon thread tape to make the connection to the tank. Inspect the draft hood that came with the new water heater to see what size flue pipe is required.