Person to inspect the water heater and replace any thermostat or insulation that has been exposed to water. Leaking faucets 7. Wasted hot water 8. Long runs of exposed piping 9. Hot water piping in exposed wall 1. Replace thermostats 2.
Where damage to property can occur in the event of the water heater leaking, the water heater must be installed in a safe tray. Construction, installation and we recommend the water heater thermostat is set at 60°C to maximise solar
Description of water heater 1)Hot water outlet 2)Temperature and pressure relief valve (30 litre only) 3)Cold water inlet 4)Control cover 5)Regulation knob 6)Heating neon The heating element is controlled by a thermostat which senses the water
Valve is leaking it must be replaced. cannot determine whether or not thermostat is opera-tional. B2. If heater is equipped with a heat exchanger, and the FROM WATER HEATER (See Fig. #1) To determine the proper setting of the gate valve (4),
WATER IS TOO HOT Adjust the thermostat to a lower setting. See the “Temperature Regulation” section. 26 LEAKAGE CHECKPOINTS Use this guide to check a “Leaking” water heater. Many suspected “Leakers” are not leaking tanks.
The thermostat of this water heater has been factory set at a position which approximates 120°F (49°C), to reduce the risk of scald injury. pipe connections may be leaking. B. Small amounts of water from the temperature-pressure relief
Gas Water Heater Exam. Fire Tubes Not Enough Hot Water No Gas To Burner No Hot Water No Hot Water No Hot Water Relief Valve Leaking Poor Burner Flame Water Too Hot Joyce Productions Thermostat Wiring (TH)
leaking gas. Before lighting, smell all around the appliance area for gas. Be sure to smell next to the floor. By setting the thermostat on this water heater to obtain the increased temperature water required by these appliances, the potential
Is any sign of leaking, the Water Heater Thermostat, the Hi-Limit Temperature Control, and the Contactor Coil are always included in the Control Circuit. Referring to the “Control Circuit Wiring Diagram”, the contactor coil is energized
leaking gas. This water heater is supplied with adjustable thermostat(s) to control water temperature. By setting the thermostat on this water heater to obtain an increased water temperature, you may create the potential for scald injury.
leaking while greatly reducing efficiency. A metal “Anode” rod within the tank STEP 2 Turn thermostat dial on the water heater so the arrow points to “A” position. STEP 3 Run about 15 gallons of hot water from the nearest faucet.
By water leaking from the water heater, pressure relief valve, or related fittings. Select a location as centralized trol/thermostat of this water heater are polarity sensitive. Ensure the electrical supply is connected correctly in the
There is also a thermostat on the heater that controls water temperature. Turn this off as well. Heating an empty tank will damage the water heater. Check the drain valve to make sure it is closed completely and not leaking. Go to the
The water heater thermostat is factory set to its lowest temperature. This may or may not be suitable for your needs. 2. Turn thermostat knob clockwise to increase water tempera- • Check for possible overhead pipes leaking onto the tank.