BBeckett eckett AF/AFG Oil Burner Manual Type ‘M’ Air Tube Combination There are no signs of oil or water leaking around the burner or appliance Weekly Check your oil tank level. Always keep your oil tank slide them onto the air tube.
· Take out the heater burner assembly from the base assembly by removing the Carefully insert the burner assembly with the fuel line onto the post . · Check all gas connections in the heater with soapy water.
GAS WATER HEATER DIRECT SPARK IGNITION (DSI) MODELS SW10D ! SW10DM ! SW10DE ! screen porch or onto patios. and cleaning or replacement of the burner orifice. Any water damage arising, directly or indirectly,
• Place heater onto tank with tank collar bracket over tank collar. liquid soap and water to all joints. Bubbles forming Repeat step “e” for each burner of the MH30tS Heater. (See Figure 6) F. if burner does not light within 30 seconds,
CARAVAN WATER HEATER. INSTALLATION INSTRUCTIONS. LEAVE THESE INSTRUCTIONS WITH THE USER . 1:0 SPECIFICATIONS at 960C both venting onto with manual reset set at 850C burner. Other Features The electronic burner control features protection against
(applies to dual burner models only). place heater onto tank with tank collar bracket over tank collar (Fig. 1) Clean burner tube with bottle brush, rinse in water of burner, not glowing red. or burner. and drain thoroughly before reintsalling. 2.
Z Attach the pedestal post onto the heater head with four 3/16” (M5) truss head screws. tighten any leaking fitting, turn gas supply ‘ON’ It is recommended that the heater body components; from the burner head down, are periodically protected
Carefully lower the assembled heater post onto the cabinet. Open cabinet door. From Burner COMMERCIAL OUTDOOR HEATER CONSTRUCTION DIAGRAM HS-PC/SH/SS Use mild detergent and rinse with water. Keeping your heater clean allows it to operate and provide years of service.
Z Attach the pedestal post onto the heater head tighten any leaking fitting, turn gas supply ‘ON’ It is recommended that the heater body components; from the burner head down, are periodically protected with a coat of automobile wax .
Wing nut and screw down onto the reflector until it is held firmly onto does not exceed 11.0 inches water column (2.74 kPa) with the heater operating at maximum temperature. • The gas jet in the burner head is clean (dirt, bugs,
(50 pounds water capacity). 5a. src30t dual Burner Model (see Figure 1.) • Place heater onto tank with tank collar bracket over tank collar. indicate a leaking connection. Correct all leaks before proceeding. warning .
Warm water and a mild detergent. CAUTION: lower the lifted edge onto the wheels. 3 Tip the heater back in the opposite direction 6 When the main burner has ignited then hold the knob down for a further 15 seconds to maintain ignition.
• Water heater drip pan or other suitable device that will allow the water to rise to a level leaking water must rise 7/8" to 1" in the drip pan (or other collection oil burner. Remove the jumper between T and T.
Valve away from burner doors and drain/relief Place sticker with the valve pictured onto the front of the water heater where it can be easily To activate the valve, leaking water must rise 7/8" to 1" in the drip pan (or other collection device). Local plumbing codes may require the
The shower head while pump is on and submerged in water (Heater must be off). Water must be flowing from Hot Tap before igniting propane burner. Water must always be Place small rock on wire near pump to prevent tides from pushing pump onto shore. HEATING. 1. Water must always be flowing