E Source, a Boulder-based firm that specializes in energy-related consulting to utilities and corporations, earlier this year moved into a new headquarters facility.
You might not be the only one looking forward to your vacation. Theft increases during the summer months largely because vacant homes make for an easy target.
* Do not expose water heater to stored chemicals like bleach and pool chemicals. Avoid corrosive atmospheres. Vent problems: Check lighting instructions. Set control knob Check and replace thermocouple Check and replace gas valve Clean or replace
Follow the Lighting Instructions (Robertshaw) given on the side of the water heater and also depicted in this manual. See also “Gas Supply”, “Water Heater Operation” and “Sequence of Operation”. Temperature Adjustment
Gas Cock Knob dial not See the “Lighting The Water Heater” section of this correctly positioned. manual. Pilot burner does not Loose thermocouple. The connection at the gas control (thermostat) should stay lit when the RED be tightened by a qualified service technician.
Have an air lock that will require an extended pilot lighting procedure. The gas valve being turned off for an extended period of time or an LP tank that has been removed to If your water heater still will not operate, seek professional
Gas Cock Knob not See the “Lighting The Water Heater” section of this correctly positioned. manual. Pilot does not stay Loose thermocouple. The connection at the gas control (thermostat) should lit when the RED be tightened by a qualified service technician.
Lighting the Gas Valve This water heater has a new, advanced gas valve and lighting the pilot is different than on older models. To light the pilot, follow the lighting instructions on the water heater’s
Fill water heater, and purge last of air by lifting TP lever, before lighting. If water heater still does not work, then install new heater. http://waterheatertimer.org/How-to-install-gas-water–heater.html Typical water heater gas valve replacement:
Water Heating, Appliances and Lighting Water heating, appliances, and lighting account for a large portion of a home’s overall energy the standard water heater does not need to add more heat. If the water is cooler than needed,
Refer to “Lighting the Water Heater” on page 34. Temperature pressure relief valve running Is the relief valve discharging too much water? 2.9 If the water heater is not sized to supply the hot water demand in accordance with the guidelines
“Yes”, proceed with lighting the heater. IV) LIGHTING & OPERATING INSTRUCTIONS Lighting Instructions (Robertshaw) FOR YOUR SAFETY READ BEFORE OPERATING The water heater is not continuously supplied with potable water; or h.
Restart the water heater following the “Lighting Instructions” found in the Operating Manual. 12. Venting System Condensate Trap Condensation Bafﬂ e Condensate Tube Screw Vent Coupling Exhaust Elbow Gasket Gear Clamp. Service Instructions
Lighting the Water Heater If the water heater has not been used for two or more weeks, follow the procedure detailed in the “Anode” section on page 13 for safe dissipation of the hydrogen gas build up inside the storage cylinder.
Building construction permits over $10,000 in value that were approved in Boulder between July 15 and July 21, 2013.
This water heater is not design certified for installation in a mobile home. Such an installation may create a hazardous condition and will nullify the FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or
FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
Before lighting an L.P. gas water heater, smell all around the appliance at floor level. If you smell gas, follow the instructions as given in the warning on the front page. Water heater not located near an air moving device.
This water heater must not be installed directly on carpeting. Carpeting must be protected by a metal or wood panel beneath under water. LIGHTING INSTRUCTIONS 1. STOP! Read the safety information above on this label. 2. Remove outer door. 3.
This water heater is not design certified for installation in a mobile home. Before lighting, smell all around the appliance area for gas. Be sure to smell next to the floor. IF YOU SMELL GAS: Do not try to light any appliance.
This water heater must not be installed directly on carpeting. Car- Be sure to check all the gas piping for leaks before lighting the water heater. Use a soapy water solution, not a match or open flame. Rinse off soapy solution and wipe dry.