Install gas water heater at least 18” off floor since gasoline vapors stay low to the ground. Turn off water heater when using solvent-base materials such as paints, stains lacquer Install CO detector to detect odorless carbon monoxide gas.
Work crews have begun demolishing and removing debris from homes destroyed by a natural gas explosion in South Philadelphia. Demolition along the affected block was set to begin Monday, one day after a Photo Credit: NBC10 Philadelphia
The structural floor and cannot contact any live electrical part. The discharge opening must not be blocked or Turn the electrical supply to the water heater "OFF". 2. Remove the access door(s) and insulation pad(s). 3. Disconnect wires from thermostat(s). 4.
The water heater to be mounted below the floor and behind a baggage door which also turns the water heater on or off. Advanced Designs Deliver Hot Water Faster Pilot Re-Light Ignition Worry-free design. Light it once and forget it.
Open drain valve and drain water heater. If there is rusty water, then check anode Rotate gas shut off handle perpendicular across line to shut gas OFF. so smell close to floor. Do not install propane heater
It is recommended the water heater be raised off the cabinet floor several inches using suitable support blocks to allow drainage of tank (not supplied). 2 B Property Damage: Do not connect the electrical power until the tank is full of water.
Metallic construction of this water heater. Make certain the floor underneath the water heater is strong enough to the water heater is "OFF" before removing any jacket access panel for any reason. Failure to do so could result
Metallic construction of this water heater. Make certain the floor underneath the water heater is strong enough to Do turn off power to water heater if it has been subjected to over heating, fire, flood, physical damage.
Hot Water Heater Information to route water into a floor drain or outdoors. turn the cold water valve on and off until the water from the drain looks clear. Close the drain valve and the hot water faucet, open the cold water valve and restore heat source. Title:
Replacing a hot water heater requires a permit in most communities.) Start by shutting off the gas at the gas meter and the water to the heater. Open the bottom 6 inches of the floor (see tank illustration). If there is a water
If a suitable floor drain is available, orient the pan's drain port toward the floor drain. NOTE: Check local plumbing codes for drain line requirements. WATER HEATER 1. Turn off supply water and gas/electricity to the water heater. 2.
A water heater is operating can most often be attrib-uted to the sludge buildup. being placed on a platform at least 18 inches off the floor. In earthquake areas, the tank should be strapped. 2. Look at the tank for any signs of corrosion or
The water heater is supplied with a high quality, factory installed, high efficiency, single walled, If the heater is to be raised off the floor, the entire bottom of the heater should be supported by a solid surface. 2.
The recently renovated South Philadelphia rowhouse that blew up this week in a natural gas explosion was thoroughly inspected and approved by city building inspectors just last week, Mayor Nutter said Tuesday, adding that he would wait for a report from city fire marshals before speculating on what caused the blast.
Some of New York's most high-profile and high-tech buildings are resorting to an ancient method to keep cool.
Energy Saver Gas Water Heater Package and Inlet Shut-Off Valve. Power Vented Water Heater Floor to Water Conn. in. 48 G Floor to Water Conn. mm. 1220
Now to the Water Heater First off, it needs to be drained, so have buck-ets, dishpans, a swimming pool hose, or other means of controlling the gallons of water that through the heater core and blown into the floor duct system.
The water heater must be level on the floor surface. Have the installer show you where the water shut-off valve for the water heater has been installed so that you know where and how to shut the water off. It is recommended that such a
The water heater is supplied as standard with a surface mounted thermostatic switch that is installed and wired at the factory. If the heater is to be raised off the floor, the entire bottom of the heater should be supported by a solid surface.
In lieu of this we run them off the re-circulating hot water system using the same time delay occu- to the water heater through a small staple up loop in the bath room floor on the way back to the water heater as . demanded by occupancy in the master bathroom.
If the heater is to be raised off the floor, the entire bottom of the heater should be supported by a solid surface. 2. Let water heater completely heat to a designated thermostat setting. b. After thermostat satisfies (that is,
DO NOT INSTALL THIS WATER HEATER DIRECTLY ON A CARPETED FLOOR. A FIRE HAZARD MAY RESULT. Instead the water heater must be placed on a metal or wood panel Turn off heater & water, repair unit. Inspect other appliances near water heater.
FLOOR DRAIN (S) GAS CONTROL VALVE/ THERMOSTAT A Z AA S BB GAS CONTROL/TEMPERATURE KNOB STATUS Cycle power to the water heater off and on. If problem persists replace the flue damper BURNER FLAME YELLOW-LAZY 1. Insufficient secondary air 2.