Outlet Water heater Wall 45º elbow Straight pipe 18" or less If a gas leak is detected at any time, close the main gas valve immediately. The Hot water outlet pipe Drawing 07 Drawing 08 *With and without LCD panels.
You've just purchased a new Marey Portable tankless water heater and will Any bubbling at a connection indicates a gas leak that must be fixed. can reverse the hookup by taking the water inlet pipe and hooking it up to the water outlet side and back.
HOT WATER OUTLET GAS SUPPLY MANUAL SHUT-OFF VALVE SEDIMENTTRAP UNION – GROUND corrugated pipe and water heater™s flue tube reducer must be hi-temp red silicone or other material suitable for 315°C All leak testing must be done with a soapy water solution. NEVER USE AMATCH OR OPEN
The outlet for use on LP gas water heaters where the Never use this water heater unless it is completely filled with water. To prevent damage to the tank, water solution. If a leak is detected, turn the gas supply off and make repairs.
Hot Water Outlet toFixtures Flue Pipe (PVC or ABS) LEAK TESTING-The water heater and its gas connections . must. be leak tested at normal operating pressure before it is placed in operation. Water Heater 3" Vent Pipe 3" Pipe Coupling
Installed on the outlet hot water pipe before th e outlet ball valve. if any soldering is done while pipes are connect ed to the heater. Run water through the supply pipe to remove all debris from the pipe before manner that if it should leak, the resulting flow of water
Installed on the outlet hot water pipe before the outlet ball valve. If a leak is present take corrective action. Open fully both inlet and outlet valves at the heater. 2) Open any hot water outlet in the system.
Use pipe sealant or Teflon tape for NPT/water heater applications. (when a nearby electrical outlet is not leak detection, watercop, floodmaster, watts, inteliflow, leaking appliance, appliance parts, plumbing parts, water heater parts, water, leak, flood, flooding, leaking, water
Supply pipe (Figure 5). 2. Move the ON/OFF switch on the gas control valve/ thermostat to the “OFF” position to turn off the water heater and unplug from the wall outlet. (Figure 22). 3. Drain the water heater. Refer to the section of “Draining Bubbles forming indicate a leak.
MATERIALS AND THE HOT WATER HEATER AND THE OUTLET HOT WATER PIPE. 6 / 25 MOUNTING INSTRUCTIONS . If you ever detect a water leak from your water heater, turn off the water supply at the shut-off valve on the inlet side of the water heater,
ELECTRIC INSTANTANEOUS WATER HEATER MODELS: EX360T12, EX480T12, EX720T12, EX960T12 NOT SOLDER PIPE TO THE INLET OR OUTLET. 2) If leak is present take corrective action. Fully open both inlet and outlet
This Technical Bulletin describes code requirements for water heater new installations and as Flood Stop) with an alarm (such as Water Alarm Leak Detector) installed in the must be added and it is not possible to pipe the pan drain line to the outside. What do I do? Answer: Cap
Natural gas leak after an earthquake. If your water heater does Hot water outlet Vent pipe Cold water inlet Flue tube/heat exchanger Flue bafﬂe Anode rod Insulation Dip tube your water heater is in an unheated basement or space.
Failure to service the anode rod at least once a year could cause the tank to fail and leak. Any water heater should be installed in such a manner that if it should leak, connections water outlet pipe tot the outlet nipple (marked with a red ring).