Powered by 69 hp Yanmar Tier IV certified emissions compliant diesel engine, Model MT 5519 features overall height of 6 ft, 4 in. and tight turning radius of 11 ft for maneuvering in confined job sites. Low-profile boom, with welded box-section design, reaches to height of 19 ft, 1 in. Additional features include 2-speed hydrostatic transmission with 3 selectable steering modes, internal wet
Combustion air flow to the water heater. The drain pan, as described above, can be purchased from your plumbing professional. The drain pan must be piped to an adequate drain. The piping must be at least 3/4 inch (1.9 cm) in
Visit www.oatey.com for updates Engineering Specification: Oatey Aluminum Water Heater Pans can be installed under gas or electric water heaters to protect from water damage.
MODEL 96 DURAPAN™ Washer/Water Heater Pan with Center/Side Drain Option E.L. Mustee & Sons, Inc. • 5431 West 164th Street • Brook Park, OH 44142 • Phone: 216.267.3100 • Fax: 216.267.9997
Jacket of the water heater. The drain pan, as described above, can be purchased from your plumbing professional. The drain pan must be piped to an adequate drain. The piping must be pitched for proper drainage. WATER CONNECTIONS
30” Aluminum Water Heater Pan with drain fitting 6 High Flow Rate #304 Stainless Steel Chrome-Plated Brass Nuts Flexible Design 15”, 18” or 24” Length 3/4” to 2” FIP • Superior engineered design • Meets code requirements
• Water heater drip pan or other suitable device that will allow the water to rise to a level of 3/4". (See drip pan sizing chart below.) • Two 3/4" male threaded x sweat adapters. • Two lengths of copper (or other approved) tubing.
— Auxiliary Catch Pan A —Diameter of water heater plus 2" min. B — Maximum 2" To open drain, line should be at least 3/ 4" ID and pitched for proper drainage. A B. The water heater is completely wired to the junction box inside jacket
Last Update: 1/30/2006 1 PLUMBING AND MECHANICAL INTERPRETATION MANUAL CODE: 2003 IRC DATE: CODE REF: Section P2801.5 SUBJECT: Water Heater Drain Pan and T& P For Tankless Water
water heater. The drain pan, as described above, can be purchased from your plumbing professional. The drain pan must be piped to an adequate drain. The piping must be at least 3/4 inch (1.9 cm) in diameter and pitched for proper drainage.
WATER HEATER PARTS LARSEN SUPPLY CO., INC. 40-1 Drip Pans & Accessories BULK NO. DESCRIPTION CTN. QTY. QTY. WATER HEATER PARTS 06/15/03 40-0050 1 Bottom or side drain drip pan
• The temperature and pressure (T&P) relief valve may discharge to the floor; the safety overflow pan serving the water heater; a waste receptor; or, the outdoors. The T&P drain line must discharge through an air gap located in the same room as the water heater.
IPS Corporation · 500 Distribution Parkway · Collierville, TN 38017 · 800-888-8312 www.ipscorp.com Plastic Water Heater Pan Specification: Furnish and install plastic water heater pan
39 Product U.P.C. Carton Ctn. No. Size Description Code Quantity Wt. ALUMINUM WATER HEATER PAN • Manufactured from prime aluminum and are expertly • Meets requirements of Southern Building Code.
The water heater catch/drain pan has protected many homes from potential flooding. But by retaining water, the drain pan has caused loss of structural integrity to the water heater’s support base, created a fire hazard and has been the cause of operational malfunctions.
Now, having waxed eloquent about driving the big boat, let me explain mechanically how I have gotten my '78 with the 400-V8 running perfectly. Very, very reliable car. Yet, any car this old, especially one that sat too much like mine, is going to need work to get it back to factory condition.
Water heater life depends upon water quality, water pressure and the environment in which the water heater is installed. • Sensors mounted in the drain pan that turn off the water supply to the entire home when water is detected in the drain pan.
E.L. Mustee & Sons, Inc. 5431 West 164th St. Brook Park, OH 44142 Phone: 216.267.3100 Fax: 216.267.9997 Email: email@example.com Web: www.mustee.com
Pressure relief valve piping to be copper or galvanized steel, not allowed to drain into water heater pan, PVC not allowed. (CPC 608.5) Combustion Air Where located in a confined space a combustion air opening must be provided within 12 inches of the top and