The temperature and pressure relief valve installed on your water heater can A metal or plastic drain pan must be installed under the water heater. c. Drain water from the water heater so that the cold water supply piping is free of water.
CONTENDER SOLAR WATER HEATER DIMENSIONS DIMENSIONS MODEL # GAL. polyethylene plastic with 2 inches of CFC free polyurethane foam insulation. WATER PRESSURE DRAIN RELIEF VALVE CIRCULATOR TANK INLET WATER VALVE EXPANSION COLD PANEL SYSTEM CONTROL
Open the water heater bypass and then the drain valve that goes down through the floor to get rid of the pressure and water in these lines. each plastic clip around the flange pair it holds together. Now it is time for testing
Hot water heater (for Jan 2005) The drain valve at the bottom of the tank is plastic so treat it tenderly and do not use pliers to turn it. There is a drain pan under the heater in case of a leak. The pan will drain any water off to the garage
Q CAUTION: The water heater’s outer jacket is plastic and can melt. q Close drain valve. q Open highest hot water faucet. q Open cold water inlet valve and fill system. H. WIRING See Figure 1 & 2 and separate TPI control wiring diagrams.
My Water Heater Pressure Relief Valve Is Releasing Water (CPVC plastic not regular PVC) pipe. The pipe size must match the opening size of the TPR valve discharge (usually ¾ inch). Connect the gauge to the water heater drain faucet
RESIDENTIAL WATER HEATER PARTS LIST MODELS: 6-30 SOMS, 6-30, 40 SORS, 6-30, 40 SHMS Series 606 3 .. Drain Valve 22" Dia. Plastic Drain Pan w/Side Drain*
Electric heater plastic Item no. 141600(-02) – 141605(-02) Main drain Light Jet Swim Inlet Filter Pump Drain Electric heater Check valve Light Install the electric heater as illustrated in a horizontal position, The heater will now heat the pool water to desired temperature.
• CAUTION: The heater’s outer jacket is plastic and can melt. • Do not install in close proximity to wood burning stove or other high Open the drain valve and direct the water to a drain. EMERGENCY Should the heater be subject to flood, fire or other damaging conditions, turn
4 1 Plastic Top 9005978 5 1 Blower Assembly (Standard) 9006683 5 1 8 1 Drain Valve 9003906 9 1 Wiring Harness 9005725 10 1 Aluminum Anode Outlet 9005981 11 1 Vent Attenuation Assembly Kit 9005982 12 1 Inlet Tube 9005983 13 1 State Water Heater Parts Fulfillment 125 Southeast Parkway
Do not install the softener where it would block access to the water heater, or access to do all sweat soldering before connecting pipes to the bypass valve. Torch heat will damage plastic parts. CAUTION: When One section will be used as a valve drain hose. The remaining
Completely flush tank water heater of water and remove heat source. standpipe arrangement at the heater drain valve opening as shown in figures 1 and 2. Note: Place a clean plastic bucket adequately sized to receive
Plastic Fasteners) Gold & Ultra Plus 30-80 633-900-102 Thermostat with Cover Plate Kit, (Includes: T-Stat, Knob, 633-900-117 Drain Valve Kit – (Includes: ¾" Drain Valve, ¾" Brass Tee, Hose Bib) Plus 30-60 Residential Water Heater Replacement Parts.
To Fill the Water Heater Make certain the drain valve is completely closed. Open the shut-off valve in the cold water supply line. access panel and plastic housing before turning on the power to the water heater. ! DANGER: There is a