Plumbing Connections 7 Temperature & Pressure Relief Valve 7-8 Filling The Water Heater 9 Electrical Connections 10 Instructions For Use 11 Maintenance Instructions 12-14 Trouble Shooting 15 Schematic Disassembly & Parts List 16 Warranty 17-18 Page 1.
Increased by modifying the plumbing. Ensure the heater and water pump are installed as low as • Check all fuel, electrical and plumbing connections. • Refill the engine coolant. • Bleed air from the coolant system by running the engine
ECO-HYBRID HEAT PUMP WATER HEATER www.northamericanhvac.com ECCO is proud to be a member of: ASHRAE American Society of same plumbing and electrical connections. *If room is less than 10' × 10' × 7' (700 cf), there must be a louvered door.
The FORTIS™ Tankless Whole House Water Heater has three plumbing connection points. These are: ¾” NPT male (BLUE) Cold Water Supply Inlet and is NOT sufficient protection for water connections to and from the heater,
Water Heater Installation Instructions and Use & Care Guide a licensed plumber or the local plumbing authority for more information. Top Water Connections Follow the mixing valve manufacturer’s instructions Cold Water Inlet Hot Water
Be sure there is ample clearance at the bottom of the heater, so that the plumbing connections are not stressed. Fig. 3 Water Supply Connections Install the water heater in such a manner that if it should leak, the resulting flow of
Installing the water heater. 1. All plumbing work must comply with national applicable state and local plumbing codes. 2. water heater. Electrical Connections A separate branch circuit with copper conductors, overcurrent protective device and suitable
SIDE PLUMBING CONNECTIONS FOR SPACE HEATING. 7 FACTS TO CONSIDER ABOUT THE LOCATION water heater to the outside wall surface is 560mm (22 in.), and the maximum height of “H” is 3.66m (12 ft.). TO BOTTOM OF HEATER WALL THICKNESS 10 in. (254mm)
All local plumbing codes for water heater installation. Copper System Full-slip female sweat, full-slip compression CPVC System CPVC socket PEX System Sweat & FIP Connections • Fits most tankless water heaters. • ¾" full port ball valves.
Plumbing cross-connections, are defined as actual or potential connections between a potable and non-potable water supply that may contribute to the degradation of the Water heater Thermal expansion occurs whenever water is heated.
With side plumbing connections for space heating. hot and cold fitting assemblies part no. 900126-2. temperature indicators temperature adjustment buttons water heater sounds condensation dripping on burner. refer to condensation above.
Large plumbing connections, 2 in. (R-16) insulation, built-in temperature sensor, and chilled water approved make these Hot Water Heater FROM DSH TO DSH PUMP HOT (Piped in series to an electric water heater) Vent Valve/ P/T Port** GEOTHERMAL DOMESTIC HW & HYDRONIC
Gas Fired Water Heater Installation . 1 GAS FIRED WATER HEATER INSTALLATION both the Michigan Plumbing and Mechanical Codes. Potable water connections are regulated as well. Section 601.1 states, in part:
The water connections to the water heater/storage unit. After the pressure has been relieved, close the faucet. the water heater and contact the plumbing professional that installed this water heater or a qualified service technician. 3.