Direct vents up to 120’ using PVC, CPVC, or ABS pipe either Thru-the-Wall or Thru-the-Roof. Optional concentric vent kit available for use Thru-the- Water heater(s) shall have a normal storage capacity of_____gallons and a recovery rate of
Tankless Water Heater Accessories Specification Sheet 3” PVC Concentric Vent NORITZ AMERICA CORPORATION 11160 Grace Avenue, Fountain Valley, • Compatible with Schedule 40 PVC/CPVC pipe and has two 3” connections for both intake and exhaust
• Supplied with PVC pipe and elbows to connect heat exchanger outlet to blower, including condensate elbow and drain • PVC Vent Attenuation Assembly Water heater(s) shall be of power vent design, using 2", 3” or 4" PVC pipe for horizontal and/or vertical vent runs.
To an outside wall, using 3" PVC or CPVC pipe. Vents up This water heater is suitable for water heating and space heating. Toxic chemicals, such as those used for boiler water treatment shall NEVER be introduced into this system.
Uses inexpensive PVC, CPVC or ABS pipe. Canadian installations require ULC S636 approved Water heater(s) shall have: 1: Seamless, glasslined steel tank construction and a spiral- shaped heat exchanger placed entirely inside the tank, which shall be
2” PVC pipe, elbows and condensate drain supplied to connect heat exchanger outlet to blower PVC Vent Attenuation Assembly (VAA) Water heater(s) shall have: 1: Glasslined steel tank construction and a spiral-shaped heat exchanger placed
Using PVC, CPVC or ABS pipe as follows: 2˝ pipe allows vent runs up to 45 equivalent feet Water heater(s) shall have: 1: Glass lined steel tank construction and a spiral-shaped heat exchanger pl aced entirely inside the tank,
Material or PVC/CPVC pipe for the exhaust vent. In fact, PVC has been used as a vent That is done through the ANSI boiler and water heater test procedures previously described. Reference to the ASTM number simply offers a means to
This water heater is supplied with a 3" Schedule 40 PVC 90° vent terminal. When venting with 4" pipe, a Schedule 40 PVC 90° vent terminal must be used. Screens for both 3" and 4" vent terminals have been included. NumbER OF mAXImum
Water Heater PVC Air Intake Pipe. Use appropriate solvent and cement to cement coupling to pipe. PVC Pipe Coupling (not supplied with water heater) Wet gasket using water with finger Male Gasketed end of PVC adapter Flue Clamp band fit over PVC Adapter
Water Heater PVC Air Intake Pipe. section of pipe for running the exhaust or intake pipe from the water heater. Insert the male end of the elbow or straight
Tankless Water Heater 3”/ 5” Concentric Direct Vent Horizontal Vent Kit Installation Instructions via the overlapping outer wall of the double wall pipe. Joints are assembled per the following steps:16 Inches A. Before assembly, observe
water heater installation manual. The entire installation must conform with the specifications pipe and fitting PVC schedule 40 ANSI/ASTM D1785 CSA or ULC certified only (ULC-S636) PVC-DWV ANSI/ASTM D2665 CPVC schedule 40 ANSI/ASTM F441 ABS-DWV
Eﬃcient gas water heater POWER VENTS USING PVC PIPE ENERGY STAR® QUALIFIED • Combined vertical and horizontal vent runs terminating through an outside wall, using Schedule 40 PVC pipe • Can be vented vertically thru-the-roof or horizontally thru-the-wall
2-Pipe Vent system designed for PVC pipe (see Use and Care Manual for specific venting requirements) U p t o3 5 f. " PVCi e r 2 A Rheem EcoSense tankless water heater will consume approximately 20 to 25% less in fuel costs than a typical gas fired tank type