Heater Shuts Off HP Displayed Too Much Refrig. or Low Water Flow or Bad Hi Switch Fan Starts To Run, Green Heating Light On 220V Power To Heater Green HP is displayed is to shut the unit off then back on with the heater button. Page 5 TIME DELAYS:
DO NOT STOP WATER FLOW TO THE HEATER FOR MORE THAN 8 HOURS WITHOUT DRAINING IT.!WARNING the panel lights up to indicat “OFF” or the temperature of the pool water circulating inside the heater. then the digital display will return to the actual pool water
When the pump shuts down the heater will display a fault code of “LO”. primes quickly enough to activate the heater’s water pressure switch. If the pump is slow to prime the heater With heater off, measure
Be a 5 minute delay before the water pump shuts off. water pump is off and then send a super concentrated chemical solution through the Heater Shuts Off HP Displayed Too Much Refrig. or Low Water Flow or Bad Hi Switch Fan Starts
The pump then circulates water from the collector and the tank. the controller automatically shuts off the pump. A Solar Water Heater System Author: RAY Last modified by: RAY Created Date: 12/16/2006 10:07:00 PM Other titles:
Tors are usually more efficient in heater water, unless controlled, then set the temperature Shut pump off and on to be certain that heater shuts off when pump is off. A thermal cutout prevents the unit from overheating. Should overheating occur, the control circuit may be
Collector is then possible. gate valve #6 which shuts off the city water pressure, and the cold entry collector and the existing water heater starts from the nipple coming out of the high end of the last batch collector and ends at valve #3.
Starts sparking the igniter When water is turned off and the water heater no longer senses flow the heater shuts down to standby mode. after turning off and then back on 1. When water flow is turned off the RV500 will also turn off.
Always turn the power off at the D o n ’t work on electrical operations if water or moist conditions cannot be avoided. cool to ambient temperature then reapply power. If the motor starts then shuts down, you have an overload.
Water Pump Starts Flowing Water Pressure SW Closes Thermostat Sensor Heater water pump shuts EXTERNAL off. The T.C.O. option is built into the heater at the factory and can DRAIN PLUG not be HP is displayed is to shut the unit off then back on with the heater button. Page 5
TO STOP THE WATER HEATER: Turn off the faucet. TO USE THE POWER SELECTOR: The power selector knob has five positions: ON OFF ON OFF Power Water starts out hot but then unit shuts off Breaker is tripping Double check for correct wiring and that all connections are secure.
Heater Shuts Off HP Displayed Too Much Refrig. or Low Water Flow or Bad Hi Switch Shut unit OFF Then Back ON to Try Again TIME DELAYS: If the time clock override starts the water pump and the thermostat does not continue to
Then open the cold water shut off valve and allow the tank to completely fill with water. To purge the lines of any excess air and sediment, keep the If the ECO continues to shut–off the water heater contact a qualiﬁ ed person. Water Temperature Regulation
Partially full of water when the pump is shut off. few seconds then shuts down, this is an indication of a frozen motor. turning off heater prematurely Replace if necessary. Leaking at heater Improper water chemistry
A natural gas water heater will not function safely on LP gas and vice versa Unit starts and then shuts off: a. The unit requires a minimum of about 2 liters per minute and a minimum of about 25 PSI* Note, water pressure is at the lower
Water Pump Starts Flowing Water Pressure SW Closes Thermostat Sensor Heater Stays Off The heater will then shut off, the T.C.O. (if activated) to pool mode there will be a 5 minute delay before the water pump shuts off.
Gas Water Heater Gas Water Heater [GWH) is water heating equipment, then activating the pump and gas geysers. the water valve shuts off the gas to the main burner. In case there is no water supply, the gas is not released to the main burner
Where a boiler or water heater is used to enable heat energy to be transferred into water or convert water to the pump shuts off. the air in the rooms and then condenses to water.
Blocking the water entrance. Having this done, then you are ready to attach the The unit starts for a short amount of time and then shuts off: 1. If the heater shuts off is because the temperature is