And the air pressure switch is not jumpered. 2 Secure power to water heater, the air pressure switch is working properly and error code 4 persists 6 Ensure water heater is not over-firing – check manifold gas pressure
Correct model water heater you are working with before servicing. Installation information given in this Service Manual is not a complete installation sensing ports on the water heater. The Blower Prover switch monitors pressure from the
This diagram shows the electric flow on the back of the water heater, through the secondary switch, to the Hi-Limit/ECO, to the Thermostat, and then to the electric element. the water heater control board may not operate correctly, causing a failure.
Temperature controls are working properly. (See water temperature regulation DO NOT place water heater in operation again until it has been thoroughly No Hot Water 1. Water Heater Switch turned off. Turn ON 2.
DTE Energy has restored power to more than 99 percent, or approximately 148,700 of the 150,000 customers impacted by the ice storm that hit Southeast Michigan last weekend.
If the blower motor is not working, then check: Pressure switch tubing is not kinked and connected water. If you introduce cold water into the tank, Turn heater off and verify continuity of orange
If your pilot model water heater is not operating properly, first check if the stove or other gas accessories are working, to verify proper gas operation. and the unit will not operate. If this occurs, turn the switch off and back on to see if it
Water Heater Thermostat and Upper Limit Switch Submitted by Robert Crouse (firstname.lastname@example.org) February 2007 Elevate the dreaded RED RESET BUTTON
The manufacturer of this water heater will not be liable for any damages caused water heater. The working pressure is stated on the water heater’s data plate. • Do not touch any electrical switch; do not use any phone in
In good condition to prevent exhaust gases from escaping into the living space where the water heater is If the vacuum switch is not open, the control attempts to If the blower motor is not working, then check: 1. Vacuum switch tubing is not kinked and connected. 2. Vacuum switch
RESIDENTIAL GAS AND ELECTRIC WATER HEATER TROUBLESHOOTING and SERVICE HANDBOOK RELIANCE Water Heater Company Technical Training Department ©2006 Ashland City, TN
Electric Water Heater (Thermostat) Repair Photo #1 Wiring Circuit Description The circuit consists of only 4 components. 1-On/Off Switch, 1-Thermostat, 1-Emergency
Exceed the maximum working pressure of the water heater (150 PSI). 1. Turn off power switch and unplug water heater from 110 VAC outlet. 2. The water heater is not continuously supplied with potable
STEP 3: Turn off the switch on the heater. (THIS IS FOR CIRCUIT CONTROL. THERE IS STILL LIVE (A working heater will have all of the lights on) Basic Tankless hot water heater operation.
Safety switch to cut off power to the water heater. A tripped breaker or blown fuse will result in total loss of hot water and is always the first thing to check. If, for any reason the tank gets too hot, the high temperature safety switch will shut
Exceed the marked hydrostatic working pressure of the water heater (150 lbs. p.s.i.) This water heater must not be installed directly on carpeting. • Do not touch any electric switch; do not use any
heater) 15 Amp, 120-277 VAC Tungsten (incandescent supplied battery is installed and working. Open the access door to reveal the battery tray, located below The remote switch(es) may not function reliably when the accumulated wire length to the remote switch(es)
Installation and operation manual direct vent gas water heater models sw6d • sw6de • sw6dm • sw6dem for installation in recreational vehicles and mobile housing