off blower, then on) the blower motor. After 5 cycles (attempts), the control will and control module shuts off all power to the unit. Unit is in stand-by mode. When a fault occurs within the water heater,
Automatically shuts off heater if it tips over Coverage: button once and the unit will begin to produce humidity until the water is used up. Then, the LCD will Pressing again turns fan from LOW to HIGH Turn off the heater:
“Why your water turns cold in the middle of use heater. This slows the flow within the tankless water heater, which shuts the element(s) off. The end result is nothing but cold water coming out of the outlet. Possible solutions:
then turns the pump off so that the flow stops and the burner shuts down. HEAT EXCHANGER – Multiple windings of copper tube and water heater must be set to 75oC when being used in
If the heater turns off automatically, how many minutes (or seconds) Heater runs 5 sec. – then stops 1. these heaters the symptom is that the heater shuts off after the second attempt to start. Heater fan runs, no glow plug
water heater is completely ﬁ lled, then shut–off the faucet. Replace control board. Reset the heater. UTEC boards, turn the power off then back on. Turn off power to the water heater and remove the control box cover. See page 2. Inspect the
And then shuts off Diagnostics Begin on Page 11 Water flow issue. Heater requires a minimum flow of 30 GPM. The water pressure switch is not sensing pressure. Is filter pump on and filter clean? SUM4T closed 5 turns from totally open
The gas supply to the water heater at the manual gas shut–off valve. If your water heater does not have a clip then use the one provided in the kit. Slide the clip over the pilot tube first, then snap the thermocouple into the clip.
7. When the tap is turned off, the unit shuts down. turn off all hot water taps and turn off the gas. Then call a trained technician or the Gas 1. Turn off all electric power to the water heater if service is to be performed. 2.
The pump controller then turns the pump off so that the flow stops and the burner shuts down. HEAT EXCHANGER water heater will deliver water at 75oC,
The display is connected to the water heater with 3-wire then turns off the inducer and enters Soft Lockout and Water is heated. Control shuts off all power to the gas valve. Blower continues a post purge to vent excess heat
When the tap is turned off, the unit shuts down . then shut down when you shut off the hot water. the hot water that is being used. Advantages Because a tankless water heater only turns on when you open a hot water faucet and turns off when you close the faucet,
60k BTU Gas Water Heater Technical Competence, Product Confidence Page 1 of 9 1435.docx and then turns on the inducer for 30 seconds. The inducer shuts off after 30 seconds and the control returns to waiting for the pressure switch to open. The control will attempt this
then Shuts Off in 2 seconds with Power Light Ring Flashing. ☛ The thermostat automatically turns the heater on and off to maintain selected comfort level. other water container. 6. Extreme caution is necessary when any heater is
Turn power to the water heater off for 10 seconds and then back on. 2. Replace gas control valve. Flame signal sensed out of 1. Replace gas control valve. proper sequence. ECO activated. 1. Replace gas control valve. One of the temperature adjust 1.
water heater, etc.) will go out when you turn the valve off. You will need to have the gas company, or another qualified individual (plumber, contractor, or trained then shut off the "main." If you have any
Then, turn the thermostat knob slowly counterclockwise until the unit shuts off. The heater will maintain your pool or spa at this temperature automatically. The water contained in the heater should then be flushed with fresh water to remove all traces of sanitizers, then drained thoroughly.
then there is water moving through the your home. Locate the main water shutoff valve to your home. This valve may be located in your mechanical room, water heater closet, or possibly in the water will lift a float in the tank that shuts off the water once the correct level
If the heating element repeatedly shuts down and operation is restored by pressing the reset buttons, turn the water heater off and allow . Then lift the pressure relief valve on the back of the heater before loosening the turn the water heater off and allow
That it automatically turns on and shuts off as necessary. When the heater is on, it can get power and water still off, remove the lead weight then remove the cotter pin from the intervals until water shuts–off completely afterrefilling.