WATER HEATER, MAKE SURE THE ELECTRICAL SUPPLY TO THE WATER HEATER IS OPERATING UNIT AND SETTING WATER TEMPERATURE IV COMMISSIONING YOUR HEATER a) Flow enough hot water to activate unit. The indicator light on the black flow control board
Powered by 69 hp Yanmar Tier IV certified emissions compliant diesel engine, Model MT 5519 features overall height of 6 ft, 4 in. and tight turning radius of 11 ft for maneuvering in confined job sites. Low-profile boom, with welded box-section design, reaches to height of 19 ft, 1 in. Additional features include 2-speed hydrostatic transmission with 3 selectable steering modes, internal wet
The water heater must be installed in a location where the proper amount of combustible air will be available c. Clean thefilter afterflushing unit withfresh water. d. Once theunit is flushed andcleansed, close A B, openC D, reconnect powerto
TANKLESS WATER HEATER Choosing a new water heater is an important decision, one that you only have to make every ten or fifteen years—so it’s important to water heater, purchase a unit that has adequate insulation (at least 1.5 inches).
ODW SERIES TANKLESS WATER HEATER UNIT WARRANTY July 2009 Parts Warranty (All Residential ODW installations) (Includes Space Heating and Domestic Water ‘Combo’ Heating
238-44965-00F REV 10/10 SOLAR ELECTRIC WATER HEATER & SOLAR STORAGE UNIT A Spanish language version of these instructions is available by contacting
Hot Water Unit Heater Mounting Height Correction Factors Note: Factors are for use with entering air temperature ranging from 0°F to 70°F. WATER TEMPERATURE DROP, (°F) Correction Factor 150 1.2 160 1.19 170 1.13 180 1.08 190 1.0 200 1.00 210 0.97 220 0.9 230 0.91 240 0.89 250 0.86 260 0.8 270
Eight people, including two children, were injured following a row home explosion and collapse in Philadelphia Monday morning.
To the "To Fill the Water Heater" sec-tion to ensure the unit is full of water before operating. 7! WARNING: The pressure rating of the relief valve must not exceed 150 PSI, (1034 KPA), the maximum working pressure of the water heater as marked on
The unit for servicing. Mounting The Water Heater Mounting kit contains sheet metal screws and supporting brackets in a plastic bag. These brackets can be attached to the back of the heater and allows the installer to secure the heater to
Of 12” before attaching to the water heater to avoid damaging the unit.! WARNING: Failure to follow the instructions provided in this manual may permanently damage the unit and void the manufacturer’s warranty. NOTICE: Do not attempt to turn any
unit is at the base of the water heater. Continuous electricity supply This type of connection is suited to where the storage capacity is less than the normal daily usage. Off-Peak electricity supply This type of connection will only allow
This instruction has been prepared to acquaint you with the service of your gas- ﬁ red water heater. Remove the screw from the top of the unit. Push the panel back and lift out. To Remove: Disconnect the electrical power to the water heater.
Inspection of the unit. 4. The water heater must not be common vented with a fireplace, wood stove or other equipment. 5. Avoid terminating the water heater vent near any air-conditioning or air-supply fans.
HVAC SUPPLIES 265 WATER HEATER HEAT RECOVERY UNIT (DESUPERHEATER) Freeze-Stat PART NO DESCRIPTION 50313 Freeze Stat (L50) Designed to operate when water temperatures of 40°F or less are detected
The Loline water heater is suitable for the heating unit to be connected to either a continuous, or a time of use, or an extended Off-Peak (overnight and day) or an Off-Peak (overnight) electricity supply.
water heater. Seem high? Not when you think about all the uses you have for hot water. Taking showers and baths, water heating unit. Start new habits. Take quick showers instead of baths. If you leave home for two days or more, turn off
Piping connections # nts unit heaters (hot water) – typical connections to vertical hot water unit heater typical connections to horizontal hot water unit heater
The water heater must be installed in a location where the proper amount of combustible air will be c. Clean thefilter afterflushing unit withfresh water. d. Once theunit is flushed andcleansed, close A B, openC D, reconnect powerto
How the Flo-Direct Gives You Top Performance and Efficiency in a Direct Fired Water Heater. Water is introduced into the top of the unit through a
WARNING! Hazard warning: Incorrect installation or repair of Webasto heating systems may cause a fire or result in the emission of carbon monoxide, which can be fatal.