From 1000 watts to 6000 watts. The wattage rating cannot be used on a single-element water heater and vice versa. Other Miscellaneous Questions Q: The Temperature and Pressure relief valve has a threaded outlet. What attaches to it?
One killowatt is equal to 1000 watts One kilowatt is equal to 3,413 BTU Recovery Rate =(KW X 3413) divided by (Temp. The temperature sensors used in this water heater are negative temperature co-efﬁ cient (NTC) thermisitors. With this type sensor,
Watts® Instant Hot Water Recirculating System Model: F500805 How much water are you wasting? pump is installed on the discharge side of the water heater. If flex pipe is used, there is no need to cut the pipe. Otherwise this procedure will be necessary.
Introducing the Watts Series TWH tankless water heater valves. Replace a bucket of fi ttings and potential leaks with our one-piece assemblies.
Watts Seismic Straps Watts Water Heater Stand Watts T&P Relief Valve Watts Drain Tube Watts Water Pressure Reducing Valve 20 30 40 50 80 100 120 Acceptance Volume Air Side Water Side Volume Pre-pressure at 150psi (gallons) (psi) DET-5-M1 DET-12-M1 DET-20-M1 DET-35-M1
Watts Watts 3/4" NPT 3" 100,000 150 Watts L100XL3-150 • Automatic re-seating relief valves used in commercial water heater applications to provide automatic temperature and pressure protection to hot water supply tanks and hot water heaters
Watts Spacemaker® SAFETY WATER HEATER INSTALLATION PRODUCTS Enclosures Stands Restraints F-Spcmkr 12/7/06 7:57 AM Page 1
Water Heater or Boiler Drain Tube WATTS CSA/ASME Temperature & Pressure Relief Valve High Temperature Hot Water WATTS Series 600 Check Valves Watts Series N170†* WATTS Series 600 Check Valves 8"-12" HeatTrap†* MMV Cold Water Supply Note: Water Heaters may be direct or indirect fired.
1000 watts to 2500 watts. Each model water heater is designed for a specific voltage/wattage rated element. hen two dissimilar metals are used for water heater inlet and outlet hook-ups (i.e., copper piping to steel tank of the heater), the connection
Demand (watts) according to the amount of hot water required at the time. In other words, they Of the total energy used by an electric water heater, approximately 85 to 95% of the electricity goes to this purpose. Any savings
WH40 ELECTRIC WATER HEATER TIME SWITCH DOUBLE POLE, 10,000 WATTS (40 AMP) MAX., 250 VOLT- 60 HZ. This Time Switch will repeat a preset schedule daily,
Watts Watts Watts-Total Volts P.S.I. U.S. Gal. IF YOU HAVE ANY INSTALLATION, PERFORMANCE OR year if the water heater is used in a commercial, or industrial application, or if the water heater is used to supply more than one dwelling unit.
used when installing the water heater, is factory installed. The cold water inlet has a vacuum relief valve connected to it. Certain conditions in the field may produce a vacuum or neg-ative pressure condition inside the water heater’s tank.
Less pressure means less water used, and therefore less energy consumed. and regulates badly without water flowing (without drawing). The WATTS INDUSTRIES direct action pressure reducing valves (PRECISIO, U5B, Hot water heater Safety unit GSE 3000
Stored or used near a water heater or furnace. A. Gas flex lines can crack. B. Flue pipes leak exhaust. C. Flex lines can separate and cause water leaks. A. B. C. MODEL E100 Shown on above www.watts.com A Watts Water Technologies Company.