Water pressure minimum bar 0.1 Servicing clearances – top/front/bottom mm 350/450/300 Servicing clearances – left/right mm 50/50 Zero compartment ventilation Yes Dry Weight kg 12.8 WALL HUNG INSTANTANEOUS GAS FIRED MULTIPOINT WATER HEATER NEXT
Consumption of your hot water returns to zero. FEATURES The water heater, including the pressure regulator provided between the gas tank and the water heater ’s gas regulator has not been reduced. See Page 2 for recommended
Instantaneous Gas Water Heater Although the RV-500 can be mounted with zero clearance around the sides, top and bottom, the water heater will suffer. The maximum inlet gas pressure must not exceed 13 water col-umn inches.
This well engineered, gas water heater has been spe- – Input BTU’s modulate to zero to prevent overheating of water from pre-heat source – Safety thermocouple at pilot burner. The water heater, including the pressure regulator provided
From the sides, zero (0) inches from the rear, four (4) pressure of the water heater (150 psi = 1,035 kPa) The water heater and its gas connection must be leak tested before placing the appliance into operation.
And the pressure at zero. 10 3. Attach the high-pressure hose to the outlet coupling on the boiler Shut off the gas supply line to the water heater. Turn gas cock knob on combination gas valve to “Off” position. Remove Boiler Assembly from
pressure gas gets wasted to the atmosphere. The Desuperheater water heater can be retrofitted on reciprocating, scroll or screw type chillers. Energy Saving People Zero pressure drop on refrigerant side across the Desuperheater.
– ASHRAE 90.1-1999 Compliant – Zero Clearance to Combustibles Residential gas-fired water heater(s) A factory installed temperature and pressure relief valve shall be provided on all models. A factory provided water
Condensing Gas-Fired Water Heater Operating and Installation Advantages Venting under positive pressure, the PLATINUM water heater eliminates the need to design a vent. • ETL listed for zero clearance from combustible walls (non-combustible floors only)
Consumption of your hot water returns to zero. FEATURES The water heater, including the pressure regulator provided between the gas tank and the water heater’s gas regulator has not been reduced. See Page 2 for recommended
(2,500,000 Btu/h) and above, in which the boiler is designed for negative or zero pressure operation. ii. especially in comparison to the cost of increasing the gas pipe capacity as part of a water heater replacement project.
Continuous Flow Gas Water Heater 1 Main Cover 5 Cold Water Inlet temperature falls below zero ° C for brief periods , the installation of an The gas pressure at the inlet test point ( Position A Figure 7) will be
Residential Gas Water Heater – • Zero Clearance to Combustibles 150 PSI working pressure and 300 PSI test pressure. The tank shall be surrounded by two inches of non-CFC foam insulation covered by an enamel coated metal jacket.
Rated temperature and pressure relief valve. PHOENIX SOLAR WATER HEATER DIMENSIONS MODEL # exhaust gas piping shall be approved for zero clearance to any combustible surface. The units total combined equivalent venting length,
VOYAGER GAS FIRED WATER HEATER SUPER HIGH EFFICIENCY GAS FIRED WATER HEATING COMBINATION APPLIANCE ANSI Z 21.10.3 and back are 0" (zero clearance). Front of the appliance needs 24" service clearance minimum. NEED 7" GAS PRESSURE UP TO 14" GAS PRESSURE